Chery Tiggo T11 LHD. Manual — part 5
Chery T11 Service Manual
Body and Accessories
-18-
2. Dismantle Right Rear Seat
1) Open the back door.
2) Pull the switch upward to fold up the right
rear seat.
3) Press the switch of back clip rod to
separate the back end of the seat from the
back clip rod.
4) Pull up the string behind the seat when it is
folded up to open the lock in front of the
seat.
5) Now it is possible to lift up the seat.
6) Install in the reversed sequence.
3. Dismantle Erection Base of Rear Seat
Just loosen the 3 fixing bolts.
Torque:
25±3Nm
Q146C1028F30 (3 pcs)
Note: Please refer to the removal procedure of
right back seat for the disassembly of left back
seat.
Switch Belt
Bolt
Chery T11 Service Manual
Body and Accessories
-19-
4. Dismantle Safety Belt
1) Remove the protection cover of upper
fixing bolts of safety belt.
2) Loosen the fixing bolts.
3) Remove the protection cover of lower
fixing bolts of safety belt.
4) Loosen the fixing bolts.
Chery T11 Service Manual
Body and Accessories
-20-
5) Remove the lower garnish of pillar C.
6) Loosen the fixing bolts of safety belt
retractor.
7) Install in the reversed sequence.
Torque:
Fix the head plate of safety belt to the
lower part of retractor
50±5Nm (1pcs)
Fix the adjusting mechanism to sliding rail
50+5Nm(1pcs)
4. Dismantle Roof Headlining
1) Dismantle the armrest of passenger.
2) Remove the front lamp indoor. (Please
refer to section Disassembly of Lamps).
3) Remove the middle lamp indoor. (Please
refer to section Disassembly of Lamps).
4) Remove the front lamp indoor. (Please
refer to section Disassembly of Lamps).
5) Remove the air admission cover.
6) Remove the shields of Pillar A, B and C.
7) Prize up the fixing clip by flat screwdriver.
8) Remove the roof headlining.
9) Install in the reversed sequence.
Fixing Seat B
Clip
Headlining
vent
Clip
Chery T11 Service Manual
Body and Accessories
-21-
Ⅳ Exterior
1. Removal and Installaiton of front door outside handle
1) Remove the left front door panel (please
refer to Removal and Installaiton of Door
Panel) and then the protection film.
2) Prize up the cover in the outside handle.
3) Dismantle the fixing bolts with hexagon
spline wrench.
4) Detach the lock element from the link rod,
remove the lock element and the cover of
left front door.
5) Remove the outside handle.
6) Install in the reversed sequence.
Torque:
Lock element fixing 11Nm
T 11-6 105243 (1 piece)
Note: Please refer to section Disassembly
and Assembly of Left Front Door for the
outer handle of right front door.
Cover
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст