Chery Tiggo T11 LHD. Manual — part 6
Chery T11 Service Manual
Body and Accessories
-22-
2. Removal and Installation of Rear Door Outside Handle
1) Remove the left rear door panel (please
refer to section Removal and Installation of
Door Panel ).
2) Peel off the protection film and loosen the
fixing bolts of handle seat with hexagon
spline wrench from one side of the shield.
3) Remove the handle seat.
4) Remove the outside handle.
5) Install in the reversed sequence.
Torque:
Handle seat fixing 11Nm
PART NO: T11-6105243(1 piece)
Note: Please refer to the Dismantle of left
back door for the right back door.
3. Removal and Installation of Back Door Outside Handle
1) Open the back door.
2) Dismantle the back door panel, and peel off
the protection film.
3) Loosen the bolt fixing the outside handle of
back door from one side of the door panel.
Fixing Point
Chery T11 Service Manual
Body and Accessories
-23-
4) Detach the pushing rod of handle from the
lock body, remove the outer handle of rear
back door.
5) Install in the reversed sequence.
Note: The lock element is fixed to the handle
with two fixing bolts at left back side,
remove the handle to detach the pull rod
from the lock elment, then remove the lock
element.
Torque:
Outside handle of back door fixing 11Nm
PART No.: T11-6305231 (3 pcs)
4. Disassembly and Assembly of Outside Rearview Mirror
1) Remove the triangle block from Pillar A.
2) Dismantle the door panel and unplug the
motor-driven outside rearview mirror.
3) Loosen the fixing screw of outside
rearview mirror.
4) Remove the outside rearview mirror.
5) Install in the reversed sequence.
Torque:
Outside rearview mirror fixing 11Nm
PART No.: T11-8202011 (3 pcs)
5. Removal and Installation of Front Wiper
1) Remove the protection cap of the fixing nut
from the wiper arm.
Chery T11 Service Manual
Body and Accessories
-24-
2) Loosen the fixing nut from the wiper arm.
3) Remove the wiper assy.
4) Dismantle the lower trim panel of front
windscreen.
Just dismantle the clips to remove the lower
trim panel.
5) Loosen the fixing bolt of linking
mechanism.
6) Unplug the motor, remove the linking
mechanism assembly.
7) Install in the reversed sequence.
Torque:
Wiper fixing 55±3 Nm
Q3 2210 (1 piece)
Linking mechanism fixing 10±1Nm
B11-5205223 (3 pcs)
Clip
Fixing Point
Chery T11 Service Manual
Body and Accessories
-25-
6. Rear Wiper
1) Prize up the decorative cap of the fixing
nut from the arm of rear wiper.
2) Loosen the fixing nut, and remove the
wiper arm and the rubber ring.
3) Open the back door.
4) Remove the back door panel.
5) Unplug the wiring harness of wiper, and
loosen three fixing bolts.
6) Install in the reversed sequence.
Torque:
Fixing the wiper arm 20±3Nm
Q3 2208(1pcs)
Fixing the wiper motor 10±1Nm
B11-5205223 (3 pcs)
Decorative Cap
Plug
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст