Chery QQ6 (S21) / S12LHD. Manual — part 16
61
Chapter 7 Disassembly/Reassembly of Instrument Panel
I. Removal of Instrument Panel Accessories
1. Preparation
Tool: socket spanner, cross head screwdriver, flat head screwdriver
Note: disconnect accumulator cathode before disassemble electrical parts
2. Disassembly/Reassembly of Central Console Panel, Audio Unit, Emergency
Switch, A/C Control Switch, Ashtray
2.1. Removal Step
2.1.1. Remove the central console panel by
hand.
2.1.2. Remove four fix screws used to joint the
audio unit and instrument panel body with a
cross screwdriver.
Torque: 9±3 Nm
2.1.3. Remove two fix screws applied to joint
the emergency switch and instrument panel
body with a cross screwdriver.
Torque: 1.5±0.5Nm
2.1.4. take off the emergency switch and pull
out the wire harness.
2.1.5. take off the audio and pull out the wire
harness.
62
2.1.6. Remove four fix screws used to joint the
A/C control switch and instrument panel body
with a cross screwdriver.
Torque: 3.5±0.5 Nm
2.1.7. Remove the fix screws (at the bottom of
ashtray) from the console, take off the cigarette
lighter connecting wire, and remove the console
assy.
2.1.8. Remove the A/C control switch cable and
harness, and then take off the A/C control
switch.
2.2. Installation Step
The installing steps are reverse to those for
removal.
3. Disassembly/Reassembly of Front
Ashtray
3.1. Removal Step
3.1.1. Draw out the front ashtray.
Bolts under
the astray
63
3.1.2. Remove one fix screw from the bottom
of front ashtray guide run with a cross
screwdriver.
Torque: 10±1 Nm
3.1.3. Remove two fix screws from the front of
front ashtray guide run with a cross
screwdriver.
Torque: 3±1 Nm
3.1.4. Take off the front ashtray guide run.
3.2. Installation Step
The installing steps are reverse to those for
removal.
4. Disassembly/Reassembly of Glove
Case
4.1. Removal Step
4.1.1. Unclench the long clip core at the right
lower part of glove case with a screwdriver, and
take off the clips.
4.1.2. Swing and take off the glove case.
4.2. Installation Step
The installing steps are reverse to those for
removal.
5.
combination
instrument
Disassembly/Reassembly of
5.1. Removal Step
5.1.1. Remove the central console panel, and
then remove the combination instrument
ornament frame.
Bolts under
the astray
64
5.1.2. Remove four fix screws from the
combination
instrument
with
a
cross
screwdriver.
Torque: 2±0.3Nm
5.1.3. Disconnec to the combination instrument
harness connector, and then take off the
combination instrument.
5.2. Installation Step
The installing steps are reverse to those for
removal.
6.
Disassembly/Reassembly
of
Combination Switch, Wiper Switch,
Ignition Switch, Heliax Cable
Please refer to Disassembly/Reassembly of
Steering Column in the Service Manual of
Chassis.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст