Chery QQ6 (S21) / S12LHD. Manual — part 132

Chapter II Removal of Trims

I. Removal and Installation of Seat belts

1. Preparations

Tools: flat head screwdriver, wrench, sleeve wrench
Spare parts: disposable clip

2. Notes

Keep the seat belts clean and free of oil, and check them for any
damage.

3. Removal Steps (Take Driver’s Seat belt as an Example)

3.1. Carefully pry up the front sill plate with a flat head screwdriver.








3.2. Remove the front door weather strip by hand.









3.3. Remove the B-pillar plate with a flat head screwdriver.

3.4. Remove the decorative covers at the upper and lower ends of
the seat belt with a flat head screwdriver.















3.5. Use a 17# wrench to loosen the upper and lower fastening nuts
before you remove the seat belt.
Installation Torque: 50±5Nm




















3.6. Pull off the seat belt warning light connector by hand.

3.7. Use a cross head screwdriver to remove the pre-tension belt
assembly.

4. Installation Steps

The installation steps are reverse to those for removal.
Note:
4.1. Keep the seat belt clean and free of oil, and check it for any
damage.
4.2. The pillar shield should fit securely with the vehicle body
without any looseness, and it should also fit well with the vehicle
ceiling and weather strip s.
4.3. The seat belt adjusting slide baffle of the upper B-pillar shield
should be able to move freely and won’t affect the adjustment of the
seat belt, and its fitting clearance with the lower shield should be
consistent and less than 1mm;
4.4. The fitting clearance between the lower B-pillar shield and the
front/rear sill plate should be consistent and less than 1mm;

II. Removal and Installation of Seats

Preparation of Tools: sleeve wrench

1. Removal of Front Seats

1.1. Move the seat by pulling at the movable handle below it, and
when the fixing bolts are shown, use a 13# socket wrench to remove
the bolts in the seat.
Torque: 25±3Nm





1.2. Pull off the seat connector and raise the seat.

2. Removal of Rear Seats

2.1. Use a 13# socket wrench to remove the fixing bolts in the rear
seat cushion.
Torque: 25±3Nm






2.2. There are two rear seat cushions, a left one and a right one,
secured by four bolts respectively.
Torque: 25±3Nm






2.3. The cushion can be dismounted when the four fixing bolts are
removed.








2.4. Pull up the pull button in the rear seat and the seat back can be
released forward (Take the left-rear seat as an example).






2.5. Use a 13# socket wrench to loosen off the two fixing bolts
below the seat back (Take the left-rear seat as an example).
Torque: 25±3Nm