Chery QQ6 (S21) / S12LHD. Manual — part 5
17
3.9. Unclench the B pillar trim with a
right-angled screwdriver.
3.10. Take off the B pillar trim.
3.11. Remove the fix screws from the seat belt
with a cross screwdriver.
3.12. Loosen the fixing nuts with a 17# sleeve,
and then take off the seat belt.
4. Installation Step
The installing steps are reverse to those for
removal.
Note:
4.1. Keep the seat belt clean, avoid the oil stain,
and check whether the seat belt is damaged.
4.2. The pillar trim shall securely fit with the
body, without any loose symptoms; and the
trim shall fit well with the ceiling and rubber
strip.
4.3. The seat belt adjusting slide baffle on the B
pillar upper trim shall move freely, without any
influence on the adjustment of seat belt, and the
fit clearance of lower trim shall be even and
below 1mm;
4.4. The fit clearance between B pillar low trim
and front/rear scuff plate shall be even and less
than 1mm;
18
II. Disassembly/Reassembly of
Seat
Tool: 16# sleeve
1. Front passenger seat removal step
1.1. Pull the moveable handle under the left
seat to move the left seat backwards and reveal
the fixing bolts under the seat.
1.2. Remove two fixing bolts before the seat.
by sleeve
1.3. Turn the moveable handle and pull
forwards the seat, and expose two fixing bolts
on the rear of seat.
1.4 Disassemble two fixing bolts at the back
of seat with sleeve.
1.5 Pull off the inserter under seat and take
away the seat.
2. Rear passenger seat removal step
2.1 Lift up the rear passenger seat cushion by
hand, and then take out the cushion from the
clips of chassis and body.
2.2. Directly take out the seat cushion by both
hands.
19
2.3. Loosen the front fixing bolts at the right
side of rear right seat with an open-end wrench.
2.4. Loosen the front fixing bolts at the left
side of rear right seat with an open-end wrench.
2.5. Pull up the ring-pull of rear right seat,
and lay down the seat forwards.
2.6. Loosen the rear fixing bolts at the right side
of rear right seat with an open-end wrench.
2.7. Loosen the rear fixing bolts at the left side
of rear right seat with an open-end wrench, and
then remove the rear right seat.
20
2.8. Loosen the front fixing bolts of rear right
seat with a open-end wrench.
2.9. Pull up the ring-pull of rear left seat, and
lay down the seat forwards.
3.0. Loosen the rear fixing bolt of rear left seat
with a sleeve, and then remove the rear left
seat.
3. Installation Step
The installing steps are reverse to those for
removal.
Installation torque is 25±3Nm
III. Disassembly/Reassembly of
Console
Tool: cross head screwdriver
1. Removal Step
1.1. Remove each two bolts at left and right
sides with a cross screwdriver, these bolts of
which are used to joint the console and front
lower guard plate.
(The tightening torque is 2±0.5N.m)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст