Chery QQ6 (S21) / S12LHD. Manual — part 6
21
1.2. Remove the bolts used to joint the console
and body lower guard plate with a cross
screwdriver.
(The tightening torque is 2±0.5N.m)
1.3. Detach the console hand brake ornament
plate by hand.
1.4. Pull out the cigarette lighter plug on the
console by hand.
1.5. Take off the console.
2. Installation Step
The installing steps are reverse to those for
removal.
22
IV. Disassembly/Reassembly of
Carpet
Tool: flat head screwdriver, cross head
screwdriver; sleeve
1. Removal Step
1.1. Remove the seat. (See Disassembly of
Seat)
1.2. Remove the scuff plate, lower trims of B
and C pillars.
(See Disassembly of B and C Pillars)
1.3. Remove the A pillar lower trim.
1.4. Remove the armrest box and console. (See
Disassembly of Armrest Box and Console)
1.5. Prize the cover on the driver pedal with flat
head screwdriver.
1.6. Remove two fixing nuts from the driver’s
pedal with a socket wrench, and then take off
the pedal.
Installation torque: 7±1N.m
1.7 Take off the carpet after Pull off the carpet
connectors
2. Installation Step
2.1. Place the carpet into the vehicle, tightedly
press the carpet near the central passage, and
expose the corresponding hole from the carpet
hole, and lay the carpet reliably.
2.2. Lay the left central rear part of carpet
according to the shape of the vehicle bottom,
and reveal the installation holes of front left
seat and lay the carpet reliably.
23
2.3. Lay the right central rear part of carpet
according to the shape of the vehicle bottom,
and reveal the installation holes of front right
rear seat and lay the carpet reliably.
2.4. Lay well the rear part of carpet according
to the shape of vehicle bottom.
V. Removal of Cushion Pad
1. Removal Step
1.1. Disassemble the carpet (See disassembly of
carpet)
1.2. Take off all cushion pads.
24
2. Installation Step
2.1. The installing steps are reverse to those for
removal.
2.2. Precautions on reassembly of cushion pad:
2.2.1. Take out the connector harness from the
seat and rear oxygen sensors when the cushion
pad is laid.
2.2.2. Make the shock absorber lower surface
joint tightly with plate work.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст