Chery QQ6 (S21) / S12LHD. Manual — part 4
13
3.1.2. Detach two locating bolts from the
luggage boot lock (the installation torque is 9±1
Nm)
3.1.3. Remove the luggage boot lock core.
3.1.4. Remove two fixing bolts from the trunk
(i.e. luggage boot) lock body with a socket
wrench.
3.1.5. Take off the trunk lock body.
3.2. Installation Step
The installing steps are reverse to those for
removal.
Precautions on installation of luggage boot
lock: check whether the lock column is
deformed, whether the riveted connections are
in its proper positions, and whether the lock
tongue can open or close flexibly, smoothly.
4. Removal of license plate lamp
Preparation of tool(s): cross screwdriver,
open-end wrench.
4.1. Removal Step
4.1.1. Remove the trunk internal ornament plate
(see Removal of trunk lid ornament plate)
4.1.2. Remove two fixing bolts from the license
plate lamp with an open-end wrench.
14
4.1.3. Disconnet the connecting plugs from the
right and left license plate lamps and then take
off the license plate lamp assy.
4.1.4. Remove two fix screws from the license
plate lamp with a cross screwdriver.
4.1.5. Take off the license plate lamp
4.1.6. Take off the bulb from the license plate
lamp.
4.2. Installation Step
The installing steps are reverse to those for
removal.
15
Chapter 2 Disassembly/Reassembly of Interior Decorations
I.
Disassembly/Reassembly
of
Seat Belt
1. Preparation
Tools: flat head screwdriver, wrench, sleeve.
Parts: disposable clips.
2. Precautions
Keep the seat belt clean, avoid the oil stain, and
check whether the seat belt is damaged.
3. Removal Step (Driver’s seat belt is
taken as an example)
Prize the front threshold pressing plate
carefully with a flat head screwdriver.
3.2. Remove the weatherproof rubber strip of
the front door opening.
3.3. Remove the rear scuff plate.
16
3.4. Remove the weatherproof rubber strip of
the rear door opening.
3.5. Remove the seat belt lower ornament
cover.
3.6. Unscrew the fixing nuts with a 17# sleeve,
and detach the B pillar lower trim.
Installation torque is 50±5Nm
3.7. Unclench the ornament cover on the seat
belt regulator with a flat head screwdriver.
CAUTION: Pay attention to the breakage of
clip inside the regulator.
3.8. Loosen the fixing nuts with a 17# sleeve,
and then take off the seat belt.
Installation torque is 50±5Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст