Chery QQ6 (S21) / S12LHD. Manual — part 125
Page 25 of 38
2.5 Trouble Checklist without Trouble Code
Table 1
Trouble
Evidence
The ABS warning lamp doesn’t illuminate when the engine is started
Possible Cause
● Burn of fuse
● Open-circuit of power line
● Burn of ABS warning lamp bulb
● Damage of ABS warning lamp control
Troubleshooting
Flow
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Short-circuit?
Replace bulb
Check if warning lamp
power circuit of ABS
harness and grounding
wire are disconnected
Replace
harness
Repair
connector
Yes
Is it normal?
Is it normal?
Does ABS
warning lamp
illuminate?
Is bulb
damaged?
Repair fuse socket
Replace fuse
Check and replace the
wiring of harness side
pin 16
Check and replace
warning lamp drive
component
Check warning lamp power
circuit
and
grounding
circuit connector
Check if the ABS
warning lamp bulb is
damaged?
Is fuse normal?
Is socket normal?
Check ABS warning
lamp fuse in fuse box
Check
fuse
socket of fuse
box
After the harness side connector
is removed, check for short-
circuit between the harness side
pin 16 and warning lamp drive
component
Remove
the
harness
side
connector and check the ABS
warning lamp when the entire
vehicle circuits are on.
Page 26 of 38
Table 2
Trouble
Evidence
The ABS warning lamp constantly illuminates after the vehicle start
Possible Cause
● Damage of ABS warning lamp control
● Open-circuit of ABS warning lamp control circuit
● ECU damage of ABS
Troubleshooting
Flow
Yes
Yes
No
No
Replace HECU
Check
and
replace
warning lamp drive
component
Check
and
replace
wiring of harness side
pin 16
After the harness side connector is
removed, confirm if it's powered
between the harness side pin 16 and
warning lamp drive component.
Connect the harness side pin 16 to
the grounding wire when the entire
vehicle circuits are on.
Is it powered?
Is warning lamp off?
Page 27 of 38
Table 3
Trouble
Evidence
Abnormal functioning of ABS
Possible Cause
● Damage of sensor
● Improper installation of sensor
● Problem of sensor harness
● Impurity adherence on sensor
● Damage of gear ring
● Damage of wheel bearing
● HCU damage of ABS
● ECU damage of ABS
Troubleshooting
Flow
No
No
No
No
Yes
Yes
Yes
Checking complete
Checking complete
Replace HECU or
connector
Replace sensor
Replace harness, connector or
HECU
Is problem
still present?
Is problem
still present?
Is the sensor correctly
installed?
Re-install the sensor
with correct method
Check if the ABS ECU
socket and connector
are normal
Page 28 of 38
Table 4
Trouble
Evidence
Brake pedal travel too long
Possible Cause
● Improper adjustment of handbrake
● Leakage of brake liquid
● Severe wearing of brake friction disc
● Leakage of normal close valve
● Air in the system
Troubleshooting
Flow
No
No
No
No
Is it normal?
Yes
Yes
Yes
Yes
Is it normal?
Is it normal?
Replace brake disc
Replace handbrake regulator
Replace HECU
Re-conduct the air
discharge
Air discharge checking
Check wearing of brake disc
Check handbrake regulator
Having leakage?
Tighten pipe connector to
120~160kgf.cm
Check hydraulic pipe
connector for leakage
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст