Chery QQ6 (S21) / S12LHD. Manual — part 9
33
5. Installation and Adjustment Step
5.1. The installing steps are reverse to those for
removal.
5.2. Adjustment of door
5.2.1. After the installation of door, check the
horizontial and vertical clearances and the
closing force of door. If the clearance is
incorrect and the closing force is big, timely
adjust the clearnace and force. See Body
Dimension for the adjustment of door
clearance.
5.2.2. The door clearance is adjusted by
regulating the fixing bolts of hinge at the body.
5.2.3. The closing force of door can be slightly
adjusted by regulating the position of front door
lock column.
Torque: 9±1Nm.
5.3. Adjustment of door glass regulator system.
5.3.1. Check the window regulator system after
this system is assembled. The duration of
window glass lifting from the lowest position to
the highest position shall be approximate 7 s.
If the time is too long, check the regulator in
time.
5.3.2 Check window regulator motor.
5.3.3. Check whether there is oil or dust in the
glass run channel which may result that the
resistance is overhigh when the window glass is
rising.
CAUTION: DO NOT apply any lubricating
grease on the glass run channel or glass so as to
avoid the adhesion of dust.
5.3.4. Check whether the installation of glass
guide is deviated from its proper position,
which may result that the glass is clamped due
to the nonuniform arc scale when the glass is
rising. The position of glass guide can be
adjusted by the guide fixing bolts.
34
II. Disassembly/Reassembly and
Maintenance of Rear Door
1. Preparation
Flat head screwdriver, cross head screwdriver,
No.7, 10, 13 sleeves and pliers.
2. Precautions
2.1 Please wear necessary labor protection
supplies to avoid accidents.
2.2 Power off accumulator to avoid damage the
electrical units.
2.3 Use the correct method to disassemble and
assemble the glass to avoid damage.
3. Removal Step
3.1. Prize two rear door glass slot protecting
boards with flat head screwdriver.
(See front door disassembly to disassemble
weather strip)
3.2. Unscew the fix screws of rear door inner
handle with a cross screwdriver.
3.3. Take off the inner handle frame by both
hands.
3.4. Separate the inner bar from the inner
handle with a right-angled screwdriver.
35
3.5. Unclench the protecting cover of glass
drive switch from the door inner guard plate
with a right-angled screwdriver.
3.6. Pull out the connector of glass drive switch
by hand.
3.7. Remove the fix screws from the front door
inner guard plate with a cross screwdriver.
3.8. Directly take off the door inner guard plate
by both hands.
3.9. Tear down front door water proof plastic
clothing.
36
3.10. Unscrew four fixing screws from front
door sound box with cross head screwdriver.
Take out sound box assembly.
3.11. Pull out the connector of front door sound
box.
3.12. Reinsert the glass drive switch into the
harness, and then descend the front door
window glass down to its lowest position.
3.13 Loosen two fixing screws on the glass
with cross head screwdriver.
And take out the glass assembly.
Torque: 4.5±0.5 N.m.
3.14. When the glass assy is being taken, erect
the glass assy so as to easily take off it.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст