Chery A15. Manual — part 195
Chery A15 Maintenance Manual
Chapter Five Bumper
I. Disassembling and installing
of the front bumper
(I) Front bumper
Disassembling and installing
1. Remove the set bolts on the
front wheel cover.
2. Loosen the set bolt between the
front fog light cover and the front bumper.
Remove the fog light cover.
3. Remove the three set bolts
between each fog light and the bumper.
4. Remove the set bolt between the
bumper holding bracket and the front beam
of the bottom plate.
Chery A15 Maintenance Manual
5. Slide the bumper forward until it is
disconnected with the clamp type bracket
on the side.
Tightening torque for the bolt on
the bumper bracket during installing is
11.9
±
1.2N.m. Tightening torque for the
bumper bracket is 82
±
8N.m.
(II) Disassembling the side bracket
Take out the fixing clamp of the
expansion seat from internal side of the
fenderboard with a plunger. Remove the
clamp bracket on the side.
Make sure that clearance between the
side skirt guard board and vehicle body,
the decorative board of rear wheel cover
does not exceed 1mm.
(III) Disassembling the bracket
Loosen the set bolt between the
bumper and the bracket and remove the
bracket.
Installing procedures for bumper are
in the reversed order. Bear in mind that
tightening torque for the set bolt between
Chery A15 Maintenance Manual
the bracket and the beam is 85N.m.The bracket of the
front bumper should be placed in a transverse
direction parallel with the ground.
II. Disassembling and installing of the
rear bumper
(I) Rear bumper
Disassembling and installing
1. Disassemble part of the rear wheel
lining board. Loosen the set bolt between
the lining board and the rear bumper.
2. Loosen the set bolt between the
luggage compartment and the lower bottom
plate of the luggage compartment.
3. Loosen the set bolt between the
bumper and the inner side of the luggage
compartment.
4. Slide the bumper backward until it
is disconnected with the clamp type bracket
on the side or the bracket.
Chery A15 Maintenance Manual
(II) Disassembling the side bracket
Take out the fixing clamp of
the expansion seat from internal side of the
fenderboard with a plunger. Remove the clamp
bracket on the side.
(III) Disassembling the bracket
Loosen the set bolt between the
bumper and the bracket. Remove the bracket.
Installing procedures for bumper are
in the reversed order. Bear in mind that
tightening torque for the set bolt between the
bracket and the beam is 85N.m.The bracket of the
rear bumper should be placed in a transverse
direction parallel with the ground.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст