Chery A15. Manual — part 201
Chery A15 Maintenance Manual
In case of any faults with it (any faults being detected during inspection, which
worsen its normal functions), note this and send it back to manufacturer with packing
of a new unit through a spare part trader.
Chery A15 Maintenance Manual
Chapter Nine Inner Lining and Decoration
I. Instrument panel
Disassembling and installing
A. Procedures within the engine housing
1. Remove the battery negative pole.
2. Remove the scraper on right side of the
windscreen. Loosen the four clamps on bottom of
the windscreen glass decorative board. Remove the
box lid.
3. Remove the two set screws on the
instrument panel from the drip rail.
B. Procedures within vehicle
1. Disassemble the steering wheel, pull the air
bag upward and remove it (see section
“Disassembling air bag”). Loosen the set
nut between the steering wheel and the steering
shaft.
Chery A15 Maintenance Manual
2. Disassemble the control and protection
switch for the light on steering column.
3. Take out the three radiator outlets by
overcoming resistance of the fixing clamp.
Remove the water glass bracket
lid and loosen the two fixing
screws on internal side.
Note: Don’t damage the cover clamps. Remove
the switch and lid on either side of the instrument
panel. Remove lid of the radio cover and the air
conditioning control cover.
4. Loosen the set screws of the instrument
panel cover and remove the cover.
5. Take out the set screws of the
instruments on the dash in the cab and disassemble
the instrument panel. Remove the switch and bottom
lid on left side of the steering wheel. Remove the
bottom lid on left side of the tool box.
Chery A15 Maintenance Manual
6. Remove the plug. Loosen the set screws
on the right surface of the instrument panel and the
screws on the gap bottom on the left side of the
tool box.
Remove the protection lid on lower right part of
the instrument panel.
7. For a vehicle with molded bottom bracket,
The dust leather sleeve on the gearshift lever should
be removed and the set bolt between the
instrument panel and the vehicle floor should be
loosened, then remove the instrument panel.
8. Remove the plug. Loosen the set screw
on the left surface of the instrument panel and the
screws on the bottom of the bracket left side.
Loosen the set screws of the control device.
9. Remove the instrument panel. Disengage
the cable from the its clamps. Remove the
necessary electrical components.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст