Chery A15. Manual — part 202
Chery A15 Maintenance Manual
Installing procedures are in the reversed
order. Bear in mind that tightening torque
for the set nut of steering wheel is 40N.m.
During disassembling and installing, take
necessary measure to avoid befouling the operation
areas which are hard to clean.
It is very important to perform cleaning during
the above operation.
II. Roof linings
Disassembling and installing
Remove the armrest, sunshield and its
bracket in accordance with the instructions.
Use the screwdriver to prize the glass on the
roof lining and the vehicle internal light and
remove them. For models with double vehicle
internal lights, remove the two lights and the
electricity wires.
Remove A column.
Remove the decorative lid. Remove part of
the sealing adhesive strips in the operation area.
Loosen the set bolt between the inner
lining and A column. Remove A column.
Remove B column
Remove the lid and loosen the set bolt
between the belt and B column; remove part
of the sealing adhesive strips in the operation area.
Chery A15 Maintenance Manual
Remove the decorative cap and loosen the
set bolt between the inner lining and B column;
remove B column.
Remove C column
Remove the decorative cap and loosen the
set bolt between the inner lining and C column.
Take out the fixing plug for the roof lining by
using the plug-extracting tool.
Chery A15 Maintenance Manual
Removal of the roof lining should be
performed by another operator, who shall pull it
out from the rear door.
Disassembling procedures are in the reversed
order. Installing angle for the right/left front safety
belt winder assembly is 0º. Tightening torque for
the check screws is 50±10N·m. Tightening
torque for set bolt of adjusting slide
is 24±5N·m. Tightening torque for set
bolt of the guide ring is 50±10N·m. Installing
angle for the rear right/left safety belt winder
assembly is 30º and tightening torque for them is
50±10N·m.
During disassembling and installing, take
necessary measure to avoid befouling the areas
which are hard to clean.
It is very important to perform cleaning during
the above operation.
III. Inner guard board of rear door
Disassembling and installing
1. Remove the set screws of the armrest
decoration. Disassemble the armrest lid and the
armrest base. Remove the guard frame of the
internal opening handle. Remove the safety handle.
Chery A15 Maintenance Manual
2. Remove the set screws between the
inner guard board and the door frame.
Installing procedures are in the reversed order.
Tightening torque for the set screws of the
internal opening handle is 1.5±0.15N·m.
During disassembling and installing, take
necessary measures to avoid befouling the operation
area. It is very important to perform cleaning
during the above operation.
IV. Passenger compartment carpet
Disassembling and installing
Remove the fixture decorations between the
door sealing adhesive strips and the carpet.
Loosen the set screws between the vehicle
floor and the safety belt. Remove the oil tray.
Disassemble the fixing plug for the carpet using the
plug-extracting tool.
Installing procedures are in the reversed order.
Bear in mind that tightening torque for the safety belt
is 50±10N·m.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст