Chery A15. Manual — part 199
Chery A15 Maintenance Manual
IV. Middle and rear rows
safety belt lock
Disassembling and installing
Fold the rear seat forwardly till the
set bolt for the lock can be touched.
Loosen the set bolt for the lock and
the bolt between the safety belt of the middle seat
and the chassis.
Installing procedures are in the
reversed order. Bear in mind that
tightening torque for the safety belt of
the middle seat and the lock is 50±10N.m.
V. Height regulator
Disassembling and installing
For the models with safety belt height
regulator, the two set bolts between it
and B column should be loosened.
Installing procedures are in the
reversed order.
VI. Internal rear view mirror
Disassembling and installing
Rotate the internal rear view mirror
until angle between its arm and the
vehicle is 15º ~20º.
Chery A15 Maintenance Manual
Installing procedures are in the
reversed order.
Adhering of glass
Remove adhesives on the glass with the
wire brush. Polish the area to be adhered
with 360/400 grain sand paper. Keep the
surface clean without any dust and grease.
Scrape off adhesive on the windscreen
with the glass scraper.
Don’t damage the protective lacker
coating, on which scratches can be normally
seen.
Mark the location of the mirror
board with the marks facing upward. Use a point
with distance A=12 mm from the lacker as the center, clean the area to be adhered
with detergent. Then dry it with
non-peeling
cloth.
Spray base coating on surface of the glass and timber. Dry them in open air for
at least 10 minutes. Dip the sealing glue filter in water and heat it to 50℃ then use it.
Evenly apply a 2mm layer of sealing material on glass surface.
For fitting of the glass fixing board, use adhesive fiber to fix it during hardening
process of adhesive. This period lasts about 14 hours.
VII. Rear coatrack
Disassembling and installing
Draw out the lift lever of the rear
door bracket. Draw out the rear panel and
disengage it from the bracket fixture.
Chery A15 Maintenance Manual
Installing procedures are in the
reversed order.
VIII. Rear loudspeaker cover
Disassembling and installing
Remove the set bolts on top and bottom
of the rear safety belt (for models with rear safety
belt). Loosen the 4 nuts on the bracket and remove
them.
Installing procedures are in the
reversed order. Bear in mind that tightening
torque is 50±10N.m.
IX. Gearshift lever
Disassembling and installing
Disassemble the dust corraguted sleeve
on the gearshift lever. Remove the set screws
between the panel and vehicle body and cause the
corraguted sleeve pass through the hole on the panel.
Remove the panel.
Chery A15 Maintenance Manual
X. Sunshield and its bracket
Disassembling and installing
After removing the bracket and the
set screws, remove the sunshield. For
models equipped with the door-control
mirror with a light, the electrical
system should be removed.
Installing procedures are in the
reversed order.
XI. Passenger armrest
Disassembling and installing
Disassemble the lid on interior armrest
end with the screwdriver and remove the
set bolt.
Take out the set bolt between the
armrest and the vehicle body. Remove the
armrest.
Installing procedures are in the
reversed order.
XII. Glove box
Disassembling and installing
Take out the set screws between the
tool box and the instrument panel and remove
the luminance and power lines. Remove the
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст