Chery A15. Manual — part 154
Chery A15 Maintenance Manual
FM3 and AM bands. Press key 1-6 in frequency memory ⒂ to save received
frequencies.
1. Manual save
When a desired frequency is searched by automatic scan, keep pressing any of keys
1-6 for three seconds, the broadcasting sound will fade and then ascend, which
indicates that the frequency has been saved to the memory key you press.
2. Automatic save
Keep pressing AS ⑩ for three seconds, the system will enter a preset automatic
procedure to search from low end to high end for radio signals with LCD ④
displaying “ATP” mark. Six frequencies with strong signals will be automatically
saved into memory, and after search is finished LCD will repeat displaying saved
frequencies with the selected memory numbers flashing for five seconds and the
corresponding program being played. Press AS ⑩ once again to stop showing saved
frequency. This automatic save is available with all of FM1, FM2, FM3 and AM
bands.
Memory Scan
Quickly press AS ⑩ once at a certain band, LCD ④ will display six saved
frequencies in turn. Selected memory number of each saved frequency will flash for 5
seconds with the program being played. To lock a desired frequency, press the
corresponding number key (1-6) to stop scanning. This memory scan is available with
all of FM1, FM2, FM3 and AM bands.
III. Additional Functions
Volume Control
In case of small volume, press loudness control "LOU" (12) for high, low frequency
tone compensation. LCD ④ will then display "LOUD" mark. Press again to
deactivate loudness control, and "LOUD" mark on LCD will dissappear.
Speaker Control
1. Knob (16) controls volume of front and rear speakers.
Chery A15 Maintenance Manual
A. This knob is preset to a balanced position by manufacturer, which means front and
rear speakers have the same volume.
B. To shut rear speakers, clockwise turn the knob to the end.
C. To shut front speakers, counterclockwise turn the knob to the end.
2. Pull out knob ① to control left and right speaker volume.
A. This knob is preset to a balanced position by manufacturer, which means left and
right speakers have the same volume.
B. To shut left speakers, clockwise turn the knob to the end.
C. To shut right speakers, counterclockwise turn the knob to the end.
D. After left and right speaker volume is adjusted, push the knob back immediately.
3. Push knob (16) in and turn to control volume and power.
Chery A15 Maintenance Manual
IV. Circuit Diagram
天线 Antenna
红 Red
至照明灯
To illuminating lamp
白 White
仪表板左扬声器
Left speaker on dashboard
灰 Gray
仪表板右扬声器
Right speaker on dashboard
兰 Blue
右后扬声器
Rear right speaker
黑 Black
左后扬声器
Rear left speaker
棕 Brown
左前门扬声器
Left speaker on front door
绿 Green
右前门扬声器
Right speaker on front door
黄 Yellow
Chery A15 Maintenance Manual
V. Installation of Audio System
Audio system includes sound source, speakers and antenna, where sound source may
be cassette player/radio assembly and optional CD player assembly or VCD player
assembly. CD player assembly and VCD player assembly consist of player, power
wire, signal wires and record changer.
1. Installing Cassette/Radio Assembly
Fit the metal frame into the secondary instrument panel, and press down the lock
pins on top, bottom, left and right sides of the frame with a screwdriver;
Connect power wire, control wire, signal wire and antenna;
Press the assembly into the frame with thumbs and forefingers applying even
force on both sides until locking sound is heard from the locking plate on both
sides.
2. Installing Antenna
Fit the antenna into the hole on roof and regulate the position;
Tighten antenna with washer and nonstandard nut, connect corresponding wires;
Lay the fore end of antenna wire harness on the rear side of cassette player/radio
or CD/VCD player, and connect the read end with antenna connectors;
Tie antenna wire harness with the left wire harness in car compartment.
3. Installing Front Speakers on Dashboard
Connect wire harness terminals;
Insert the speakers into hole sites with terminals at left side, and turn rightward
to fix (note the terminals must to pointing to driver's position after fixing to
avoid short circuit).
Press to fit speaker cover in proper direction.
4. Installing Speakers on Front Door
Connect wire harness, insert the speakers to the fit sites on front door and fix it;
Tighten four tapping screws;
Press to fit speaker cover in proper direction.
5. Installing Rear Speakers
First fit properly the speaker covers (speaker terminals pointing inward);
Fit two rubber washers on each of the four plastic poles and tighten the nuts;
Connect wire harness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст