Chery A15. Manual — part 197
Chery A15 Maintenance Manual
105
After installing and adjusting, it must be assured that the glass can be lifted and
lowered stably and smoothly. No shaking, vibrating or shocking of glass is allowed.
Lifting-lowering period should be 3
±
1S.
Chery A15 Maintenance Manual
Chapter Seven External Accessories
I. Fuel port lid
When disassembling the fuel port lid,
loosen the two set screws on vehicle
body side.
Installing procedures are in the reversed order.
Maintain a dimension of (4±0.5)mm. Average
error between the lid edge and the rear fender is
±0.5mm so as not to affect vehicle appearance.
II. External rear view mirror
Disassembling and installing
When disassembling the rear view mirror,
disassemble the internal guard plate of
the front door according to instructions.
1. Disassemble the inner quarter block
of the rear view mirror.
2. Remove the three set screws between
the rear view mirror and the internal plate
of the front door. Pull out the plug for
Chery A15 Maintenance Manual
the rear view mirror. Remove the rear view
mirror.
Installing procedures for rear view
mirror are in the reversed order. Tightening
torque for the bolt is 3±0.3N.m.
III. Rear view mirror glass
Disassembling and installing
1. Prize the top and bottom of the external
rear view mirror with the disassembling
tool for the rear view mirror glass to
disengage it from the roll ball joint and
the hook. Be careful not to damage the
rear view mirror frame.
When fitting it, place the glass and
the guide pin in place and only center of
the glass can be pressed. Wear protection
gloves.
IV. Radiator grill
Disassembling and installing
When disassembling the radiator grill, first
remove the four set bolts between its top and
the front panel, then remove the radiator grill.
Installing procedures are in the reversed order.
Tightening torque is 3.5±2N.m.
Chery A15 Maintenance Manual
V. Inner guard board of the
luggage compartment
Disassembling and installing
1. Remove the eleven set bolts on
outer frame of the inner guard plate
of the rear lid. Then knock open the
plastic clamp with the screwdriver.
Remove the inner guard plate of the
rear lid.
2. Loosen the set screw between the
button and the molded decoration frame
of the rear door. Remove the molded decoration.
Installing procedures are in the
reversed order. Remember the position of
the rear door opening button.
VI. Roof decorative strip
Disassembling and installing
Begin prizing from the rear window glass
with the plastic wedge and loosen the clip
of drip rail with hands. Open the clips
with the screwdriver and remove them. The
clips can’t be reused.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст