Chery A15. Manual — part 198
Chery A15 Maintenance Manual
Installing procedures are in the reversed
order. Remember to replace all clips with
new ones.
VII. Front wheel cover fenderboard
Disassembling and installing
Loosen the set screws between the
front wheel cover and the fenderboard.
Installing procedures are in the
reversed order.
VIII. Rear wheel cover fenderboard
Disassembling and installing
Loosen the set screws between the
rear wheel cover and the fenderboard.
Installing procedures are in the
reversed order.
Chery A15 Maintenance Manual
Chapter Eight Internal Accessories
I. Front seat safety belt
Disassembly and installation
Disassemble doorsill scuff strip and
remove part of doorframe weather strip.
Remove the cover and loosen the set bolt
between safety belt and pillar B.
Chery A15 Maintenance Manual
Remove the nut, loosen the bolt on inner
lining of pillar B, and remove the upper
garnish of pillar B.
Loosen the two setscrews on the bottom
plate of pillar B and remove lower
garnish of pillar B.
Remove the decorative cover and loosen
the set bolts between safety belt and
vehicle floor, then the set bolt between
automatic locking device and pillar B.
Chery A15 Maintenance Manual
Loosen the set bolt for the turn plate and remove the turn plate. Then remove the belt
unit. Be careful not to make the belt twisted.
Installation procedures are in reversed order. Bear in mind that tightening torque for
set bolt between the safety belt and the automatic turning device is 50±10N•m. The
left seat safety belt shall turn 180º to the right and the right seat safety belt shall turn
180º to the left, as shown in the above figure.
II. Front seat safety belt lock
Disassembly and installation
Loosen the set bolt between the lock and the front seat frame.
Place the safety belt lock on upper part of the fixing lever while installing. Tighten the
set bolt with a tightening torque of 50±10N.m.
III. Rear seat safety belt
Disassembling and installing
Remove the decorative top of the nut.
Loosen the two set bolts between the
safety belt and C column and the rear wheel
cover.
Loosen the set bolt of the automatic
winder and fold the safety belt. Be careful
not to twist the belt because the belt has
been disengaged from its fixing device and
the belt is reversely wound around the automatic
winder.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст