Chery A11. Manual — part 55
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Press differential oil sealing 09 130 into location
with installing sleeve 5×46 000 299.
Install shift shaft oil sealing 06 010 with special
spindle drift 5×46 000 187.
Knock rolling pin 06 030 into pawl spring 06 020
with a plastic hammer.
-67-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Insert brake rotor dowel pin 06 100 and adjusting
piece 5P 89 001 995.
Install pawl spring dowel pin 06 040, and then
install the pawl spring.
Keep pawl spring close to the adjusting piece,
and then fix with two bolts 06 050.
Tool: 27# inner socket spanner
Torque: 10Nm
Insert shift shaft 06 060 half or so, then install
shift cam 06 070 into shift shaft, and assemble
shift shaft to stop.
-68-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Connect locking cam 24 020 and brake rotor 06
110 with the lock spring 24 010. Locking cam
must be installed on brake rotor.
Install the whole mechanism on the dowel pin,
and connect the brake rotor and lock cam with
spring.
Shift cam and lock cam MUST BE adjusted to
installation position. Install brake rotor and adjust
its location as shown on figure.
-69-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
NOTE:
The washer thickness should be adjusted as
procedures in section 1.4.1 in page 5/1. The
adjusting washer is installed between the cam
and the housing. Therefore brake rotor must be
removed, and pull shift shaft out enough as
necessary.
Install shift shaft elastic pin 06 090 with special
tool 5×46 000 119 and a hammer.
NOTE: The elastic pin opening side must face to
transmission input or output direction.
Insert pawl dowel pin 24 060 half into the house,
and place retracting spring 24 050 on dowel pin.
-70-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст