Chery A11. Manual — part 56
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install pawl 24 040 on dowel pin, and then install
dowel pin to stop.
Connect return spring and the pawl, and push
the spring outward.
Install the parking plunger 24 030.
As shown on figure, place return spring 06 140
on throttle valve cam 06 120..
-71-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
3.2、Installing band brake C’
Install O-ring 31 340 on groove on brake band
plunger 31 330 end. Oil O ring before installing.
-72-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Insert plunger into the housing, with O-ring end
facing outward for sealing.
Install adjusting blot 31 350, washer 31 360, and
adjusting nut 31 370, and screw bolt into housing
half or so.
Installing piston C’
Place washer 31 400 (thick) on piston plunger 31
390, then install elastic washer 31 404 (thin).
NOTE:
Both washers are of U shape. When installing,
concave side face each other, and move them to
the piston shoulder.
Install new O-ring 31 420 on the brake band
piston.
Install brake band piston on piston rod.
NOTE:
Piston flange must be at safety snap ring 31 450
side.
-73-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Place spring 31 430 on piston.
After oiling O-ring, mount whole piston into the
housing.
Place 2 O rings 31 470 on brake fluid hydraulic
cylinder cap and apply oil or Vaseline, and then
install cylinder cap.
Press cylinder cap using special tool 5 X 46 000
295, and then install snap ring.
Remove the special tool.
-74-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст