Jaguar XJ (X350). Manual — part 1085

Remove and discard the gasket.

Installation

1

.

CAUTION: Make sure the catalytic converter is fully supported during installation.

Failure to follow this instruction will result in damage to the catalytic converter decoupler

joint.

CAUTION: Never use jointing compound forward of the catalytic converter.

NOTE:

Right-hand shown, left-hand similar.

Loosely install the catalytic converter.

Install a new gasket.

Install the retaining bolts.

2 . NOTE:

Right-hand shown, left-hand similar.

Install new retaining nuts.

Tighten to 22 Nm.

3 . NOTE:

Right-hand shown, left-hand similar.

Install the catalytic convertor to particulate filter retaining clamp.

Tighten to 11 Nm.

www.

4 . NOTE:

Right-hand shown, left-hand similar.

Fully tighten the catalytic converter bracket retaining bolts.

Tighten to 25 Nm.

NOTE:

For vehicles prior to VIN H16767, refit old fixings and tighten to 22 Nm.

5 . NOTE:

Right-hand shown, left-hand similar.

Attach the catalytic converter temperature sensor wiring harness to the transmission.

6 . NOTE:

Right-hand shown, left-hand similar.

Connect the catalytic converter temperature sensor electrical connectors.

7 . Install the air deflector.

For additional information, refer to Air Deflector (76.11.41)

www.