Jaguar XJ (X350). Manual — part 1086
Diesel Particulate Filter (DPF)
Removal
1 . Raise the vehicle.
For additional information, refer to Lifting
2 . Loosen the front muffler retaining clamps.
3
.
Remove the diesel particulate filter mount bracket.
Remove and discard the diesel particulate filter mount bracket retaining
nuts.
4 . Disconnect the diesel particulate filter temperature sensor electrical connector.
5
.
NOTE:
Note the orientation of the diesel particulate filter high-pressure and low-pressure hoses
and make sure they are installed in the same position. There is a paint mark to identify
their position.
Detach the diesel particulate filter high-pressure and low-pressure hoses.
6 . NOTE:
Right-hand shown, left-hand similar.
Remove the diesel particulate filter to catalytic convertor retaining clamps.
www.
7 . Using an assistant remove the diesel particulate filter.
Installation
1 . NOTE:
Right-hand shown, left-hand similar.
To install, reverse the removal procedure.
Tighten to 11 Nm.
2 . Tighten to 55 Nm.
3 . NOTE:
Install new diesel particulate filter mount bracket retaining nuts.
Tighten to 9 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст