Jaguar XJ (X350). Manual — part 406

NOTE:

The crankshaft retaining bolt will be very tight.

Using special tools, retain the crankshaft pulley.

Remove and discard the crankshaft pulley bolt.

7 . Remove the special tools.

8 . NOTE:

The crankshaft pulley will be very tight.

Using special tools, remove the crankshaft pulley.

Collect the locking ring.

Remove and discard the O-ring seal.

9 . Remove the special tools.

10

.

Remove the crankshaft front seal.

For additional information, refer to Crankshaft Front Seal - VIN Range: G00442->G45703

(12.21.14)

For additional information, refer to Crankshaft Front Seal - VIN Range: G45704->G99999

(12.21.14)

11 . NOTE:

Check crankshaft pulley and locking ring for damage.

Clean all crankshaft pulley mating faces.

Installation

All vehicles

1

.

Install a new crankshaft front seal.

For additional information, refer to Crankshaft Front Seal - VIN Range: G00442->G45703

(12.21.14)

For additional information, refer to Crankshaft Front Seal - VIN Range: G45704->G99999

(12.21.14)

2 . Install a new O-ring seal to the crankshaft pulley.

Lubricate the new O-ring.

www.

3

.

CAUTION: The screw thread in the crankshaft must be cleaned out before a new

crankshaft pulley bolt is installed.

CAUTION: A new crankshaft pulley bolt must be used.

Install, but do not tighten, a new crankshaft pulley retaining bolt.

Install the crankshaft pulley and locking ring to the crankshaft.

4

.

CAUTION: Under no circumstances should the crankshaft setting peg 303-645 be

used in the following operations to lock the crankshaft.

Using special tools, retain the crankshaft pulley.

Tighten the crankshaft pulley retaining bolt to 320 Nm.

5 . Remove the special tools.

Vehicles without supercharger

6 . Raise the vehicle.

7 . Attach the oil cooler.

Install a new O-ring seal.

Tighten to 55 Nm.

8 . NOTE:

Apply a suitable amount of clean engine oil to lubricate the oil filter O-ring seal.

Using special tool, install a new oil filter.

Tighten to 18 Nm.

www.