Jaguar XJ (X350). Manual — part 1069

Remove the transmission fluid cooler tubes.

Allow the transmission fluid to drain into a suitable container.

Installation

1 . NOTE:

Install new O-ring seals.

Install the transmission fluid cooler tubes.

Tighten to 23 Nm.

2 . Attach the transmission fluid cooler tube retaining bracket.

3 . Detach the steering gear.

4 . Attach the steering gear.

Tighten to 100 Nm.

5 . Attach the lower steering column.

Tighten to 35 Nm.

www.

6 . Connect the power steering control valve actuator electrical connector.

7

.

Make sure that the alignment mark on the steering gear pinion seal protection cover is central

to the steering gear pinion casting.

8 . NOTE:

Install new O-ring seals.

Attach the transmission fluid cooler tubes.

Tighten to 10 Nm.

9 . Install the left-hand splash shield.

10 . Install the catalytic convertor.

For additional information, refer to Catalytic Converter - 2.7L V6 - TdV6 (17.50.05)

11 . Carry out a transmission fluid level check.

For additional information, refer to Transmission Fluid Level Check

www.