Jaguar XJ (X350). Manual — part 1068
Vehicles with 3.5L or 4.2L engine
11 . Install the air cleaner. <<303-12B>>
Vehicles with 3.0L engine
12 . Install the air cleaner. <<303-12A>>
All vehicles
13 . Carry out transmission fluid level check. <<307-01>>
Transmission Fluid Cooler Tubes - 2.7L V6 -
TdV6 (44.24.19)
Removal
1 . Center the steering wheel.
Lock in position, remove the ignition key.
2 . Remove the catalytic converter.
For additional information, refer to Catalytic Converter - 2.7L V6 - TdV6 (17.50.05)
3 . Reposition the left-hand splash shield.
4 . NOTE:
Discard the O-ring seals.
Detach the transmission fluid cooler tubes.
Allow the transmission fluid to drain into a suitable container.
www.
5
.
Make sure the alignment mark on the steering gear pinion seal protection cover is central to
the steering gear pinion casting.
6 . Disconnect the power steering control valve actuator electrical connector.
7 . Detach the lower steering column.
Remove the steering gear shaft pinch bolt.
8 . Detach the steering gear.
Remove the steering gear retaining bolts.
9 . Using a suitable piece of string, secure the steering gear.
10 . Release the transmission fluid cooler tube retaining bracket.
11
.
CAUTION: Make sure that the transmission fluid cooler tubes are not removed
from the automatic transmission by using a pry bar. Failure to follow this instruction may
result in damage to the vehicle.
NOTE:
Discard the O-ring seals.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст