Jaguar XJ (X350). Manual — part 1184

Operate the brake pedal to allow the speed control deactivator switch to

remain in the fully extended position during installation.

Releasing and then pulling back on the pedal untill the pedal reaches the

stop in the brake booster, will adjust the speed control de-activator switch

plunger to the required setting.

Speed Control Module (19.75.26)

Removal

1

.

CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to

these charges, damage may result.

NOTE:

Make sure the audio unit keycode is available before disconnecting the battery ground

cable.

Disconnect the battery ground cable.

For additional information, refer to Battery Disconnect and Connect

2 . Remove the driver side instrument panel lower trim.

3 . Remove the instrument panel trim.

4 . Disconnect the speed control module electrical connector.

www.

5 . Remove the speed control module.

Remove the speed control module retaining nuts.

Installation

1 . Install the speed control module.

Tighten to 5 Nm.

2 . Connect the speed control module electrical connector.

3 . Install the instrument panel trim.

4 . Install the driver side instrument panel lower trim.

5 . Connect the battery ground cable.

For additional information, refer to Battery Connect (86.15.15)

6 . Using the approved Jaguar diagnostic system configure the speed control module.

www.