Jaguar XJ (X350). Manual — part 1185

Speed Control Sensor

Removal

All vehicles

1 . Disconnect the battery ground cable.

For additional information, refer to Battery Disconnect and Connect

2 . Remove the radiator splash shield.

For additional information, refer to Radiator Splash Shield (76.22.90)

3 . Disconnect the speed control sensor electrical connector.

Vehicles built up to VIN:H18680

4 . Remove the left-hand front bumper access cover.

All vehicles

5 . Remove the speed control sensor.

Remove the bolts.

6 . Remove the speed control sensor retaining bracket.

Remove the nuts.

Installation

All vehicles

1 . Install the speed control sensor retaining bracket.

Install the nuts.

Tighten to 5 Nm.

www.

2

.

Adjust the speed control sensor leveling bolt shoulder to mounting bracket clearance to 4.5

mm.

3 . Install the speed control sensor.

Tighten to 5 Nm.

4 . Connect the speed control sensor electrical connector.

5 . Connect the battery ground cable.

For additional information, refer to Battery Connect (86.15.15)

6 Check and adjust the speed control sensor leveling.

.

For additional information, refer to Speed Control Module Alignment - VIN Range: G00442-

>H18679

Vehicles built up to VIN:H18680

7 . Install the left-hand front bumper access cover.

All vehicles

8 . Install the radiator splash shield.

For additional information, refer to Radiator Splash Shield (76.22.90)

9

.

Initialize the system. For additional information, refer to the Jaguar approved diagnostic

system.

www.