Jaguar XJ (X350). Manual — part 1503

2 . Make sure the new windshield glass surface is clean using Betawipe spirit.

3 . Apply glass primer to the mating surface of the windshield glass.

4 . Install the windshield finisher to the windshield glass.

Install new windshield finisher retaining clips.

5 . Apply glass primer to the mating face of the body flange.

6

.

Cut adhesive nozzle to achieve a triangular section bead 7 mm (0.28 in) wide by 10 mm (0.39

in) high.

7

.

Using a suitable pneumatic application gun, apply a uniform bead of adhesive to the

windshield glass edge commencing at the bottom center and overlapping the ends

approximately 20 mm (0.79 in).

8

.

CAUTION: When installing the windshield glass, do not strike it in any way as this

will crack the windshield glass.

With assistance carefully install the windshield glass into the aperture.

www.

9 . Remove the lifting handles.

10

.

CAUTION: Make sure the windshield glass does not move out of position in the

windshield glass aperture.

Apply suitable adhesive tape to the top of the windshield glass.

11 . Install the cowl vent screen. <<501-02>>

12 . Remove the protective tape around windshield glass aperture.

13 . Remove protective tape from the leading edge of the headliner.

14 . Remove the protective sheet and the protective board from the fascia.

15 . NOTE:

Left-hand shown, right-hand similar.

Connect the heated windshield electrical connectors.

16 . Remove the adhesive tape supporting the headliner.

www.