Jaguar XJ (X350). Manual — part 1254

10 . Remove the recirculation blend door actuator.

Installation

1 . NOTE:

Ensure the recirculation blend door operating lever is correctly located.

To install, reverse the removal procedure.

2 . Tighten to 7 Nm.

3 . Tighten to 7 Nm.

www.

Sunload Sensor (82.20.70)

Removal

1 . Detach the sunload sensor trim panel.

2 . Disconnect the sunload sensor electrical multiplug.

3 . Remove the sunload sensor.

Installation

1 . To install, reverse the removal procedure.

413 : Instrument and Warning Systems

413-00 : Instrument Cluster and Panel Illumination

Diagnosis and testing

Instrument Cluster and Panel Illumination

1 . Verify the customer concern.

2 . Visually inspect for obvious signs of mechanical or electrical damage.

Visual Inspection Chart

Mechanical

Electrical

•

Fluid level(s)

•

Accessory installations

•

Bulbs(s)

•

Fuse(s)

•

Wiring harness

•

Electrical connector(s)

•

Engine compartment components

•

Underbody components

•

Instrument cluster

•

Front electronic module (FEM)

•

Dimmer switch

•

Headlamp switch

•

Autolamp sensor

•

Ignition switch

1 . If an obvious cause for an observed or reported concern is found, correct the cause (if possible)

before proceeding to the next step.

2 . If the cause is not visually evident, verify the symptom and refer to the Jaguar approved diagnostic

system.

www.