Jaguar XJ (X350). Manual — part 544

Make sure the crankshaft rear seal mating faces are clean and dry.

Apply a 8 mm bead of sealant to the cylinder block in the areas shown.

For additional information, refer to Specifications

2 . Tighten to 10 Nm (7 lb.ft).

3 . Tighten to 10 Nm (7 lb.ft).

4 . Install the CKP sensor ring.

For additional information, refer to Crankshaft Position (CKP) Sensor Ring

1 . NOTE:

Crankshaft Vibration Damper (12.21.09)

Special Service Tools

Accessory belt detensioner

303-703

Removal

1 . Disconnect the battery ground cable.

For additional information, refer to Battery Disconnect and Connect

2 . Remove the air deflector.

For additional information, refer to Air Deflector (76.11.41)

3 . Detach the accessory drive belt.

1) Using the special tool, rotate the belt tensioner counter clockwise.

2) Detach the accessory drive belt.

4 . Remove the crankshaft vibration damper.

www.

Installation

1 . To install, reverse the removal procedure.

Tighten to 14 Nm.

Cylinder Head LH (12.29.02)

Removal

1 . Remove the left-hand camshafts.

For additional information, refer to Camshafts LH (12.13.19)

2 . Remove the exhaust manifold.

For additional information, refer to Exhaust Manifold LH (30.15.55)

3 . Detach the expansion tank hose from the cylinder head coolant outlet assembly.

4 . Detach the engine coolant hose from the cylinder head coolant outlet assembly.

5 . Detach the radiator top hose from the cylinder head coolant outlet assembly.

www.