Jaguar XJ (X350). Manual — part 543

6 . Using the special tool, fully install the crankshaft front seal.

Install the crankshaft pulley retaining bolt.

7 .

CAUTION: The crankshaft pulley retaining bolt must not be re-used.

Remove the special tool.

Remove and discard the crankshaft pulley retaining bolt.

8 .

CAUTION: The crankshaft pulley retaining bolt must not be re-used.

CAUTION: The crankshaft pulley retaining bolt must be tighten in two stages.

Install the new crankshaft pulley retaining bolt.

Stage 1: Tighten to 100 Nm.

Stage 2: Tighten to 90 degrees.

9 . Remove the special tool.

10 . Install the special tool.

www.

11 . Install the starter motor.

For additional information, refer to Starter Motor - 2.7L Diesel (86.60.01)

12 . Install the timing belt.

For additional information, refer to Timing Belt

Crankshaft Rear Seal (12.21.20)

Removal

1 . Remove the crankshaft position (CKP) sensor ring.

For additional information, refer to Crankshaft Position (CKP) Sensor Ring

2 . Remove the crankshaft rear seal retaining bolts.

3 . Remove the crankshaft rear seal.

Remove the retaining bolts.

Installation

CAUTION: Make sure the crankshaft rear seal is installed correctly.

www.