Range Rover Body Repair Manual — part 17
SUPPLEMENTARY RESTRAINT SYSTEM
3
REPAIR
SRS HARNESS - SINGLE POINT SENSED SYSTEM
Service repair no - 76.73.73
The SRS harness is incorporated into the fascia
harness.
See ELECTRICAL, Repair.
SRS HARNESS - DISTRIBUTED SYSTEM
Service repair no - 76.73.73
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove battery.
See ELECTRICAL, Repair.
3. Remove centre console.
See CHASSIS AND
BODY, Repair.
4. Remove passenger air bag module.
See this
section.
5. Remove radio.
See ELECTRICAL, Repair.
6. Remove instrument pack binnacle.
See
INSTRUMENTS, Repair.
7. Remove 5 screws securing switch pack to
fascia.
8. Disconnect switches, clock and temperature
sensor. Remove switch pack.
9. Remove 4 screws securing heater control panel.
10. Disconnect multiplugs. Remove control panel.
11. Release door aperture seal adjacent to A post
lower trim panels.
12. Driver’s side - LHD automatic vehicles only:
Remove 3 bolts securing foot rest. Remove foot
rest.
75
SUPPLEMENTARY RESTRAINT SYSTEM
NEW RANGE ROVER
4
REPAIR
13. Remove screw securing each A post lower trim
panel. Release panels from sprag clips. Remove
both trim panels.
14. Remove 4 scrivet fasteners securing drivers side
lower closing panel.
15. Disconnect footwell lamp multiplug. Remove
closing panel.
16. Disconnect SRS harness from main harness.
Release multiplug from clip.
17. Remove sound deadener pad from transmission
tunnel.
18. Disconnect multiplug from SRS ECU. Release 3
harness clips.
19. Remove both front wheel arch liners.
See
CHASSIS AND BODY, Repair.
SUPPLEMENTARY RESTRAINT SYSTEM
5
REPAIR
20. Remove 2 trim studs securing air cleaner baffle
beneath LH wheel arch. Remove baffle.
21. Disconnect both SRS crash sensor multiplugs.
22. Remove 4 bolts securing battery tray.
75
SUPPLEMENTARY RESTRAINT SYSTEM
NEW RANGE ROVER
6
REPAIR
23. Remove 2 bolts securing air cleaner to valance.
24. Raise air cleaner and battery tray to gain access
to crash sensor harness clips.
25. Release clips securing each crash sensor
harness to valance.
26. Release harness grommets. Feed both
harnesses through valance into wheel arches.
27. Release 3 clips securing each crash sensor
harness to underside of wheel arches.
28. Release harness bulkhead grommets. Feed
harnesses through bulkhead into passenger
compartment.
29. Disconnect SRS multiplug from instrument pack.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст