Discovery 2. Manual — part 650
DOORS
REPAIRS 76-1-13
Handle - exterior - front door
$% 76.58.07
Remove
1. Remove front door trim casing.
2. Carefully release water shedder from door.
3. Release control rod from latch.
4. Remove Torx bolt securing exterior handle to
door.
5. Remove exterior handle.
6. Remove control rod from exterior handle.
Refit
1. Fit control rod to exterior handle.
2. Position exterior handle to door, fit Torx bolt
and tighten to 7 Nm. (5.2 lbf.ft).
3. Connect control rod to door latch.
4. Fit water shedder to door.
5. Fit front door trim casing.
DOORS
76-1-14 REPAIRS
EXTERIOR FITTINGS
REPAIRS
76-2-1
EXTERIOR FITTINGS
REPAIRS
Wing - front - up to 03MY
$% 76.10.24
Remove
1. Remove front repeater lamp.
LIGHTING, REPAIRS, Lamp - front
2. Remove front wheel arch liner.
3. Remove 5 screws securing wheel arch liner
extension to bumper valance and remove liner.
4. Remove side repeater lamp from wing,
disconnect multiplug and remove lamp.
5. Remove bolt securing front of wing to bracket
on body.
6. Remove screw securing headlamp surround
panel to wing.
7. Remove nut securing wing to bracket on sill
finisher.
EXTERIOR FITTINGS
76-2-2
REPAIRS
8. Remove 8 bolts securing wing to body and
remove wing.
Refit
1. Position wing to body.
2. Connect side repeater lamp to multiplug and fit
to wing.
3. Position wing to body, align wing to bonnet and
front door so that the correct gaps are achieved
and tighten bolts to 17 Nm (13 lbf.ft).
4. Check alignment of wing to bonnet and front
door. If necessary, adjust wing to achieve
correct gaps.
5. Fit and tighten nut securing wing to bracket on
sill finisher to 17 Nm (13 lbf.ft).
6. Fit and tighten screw securing wing to
headlamp surround panel.
7. Fit and tighten bolt securing front of wing to
bracket on body to 17 Nm (13 lbf.ft).
8. Fit wheel arch liner extension to bumper and
secure with screws.
9. Fit front wheel arch liner.
10. Fit front repeater lamp.
LIGHTING, REPAIRS, Lamp - front
Wing - front - from 03MY
$% 76.10.24
Remove
1. Remove the headlamp assembly.
2. Remove the front wheel arch liner.
3. Remove screw securing wheel arch liner
extension panel to the inner wing.
4. Remove 6 screws securing wheel arch liner
extension panel to the front bumper and
remove the extension panel.
5. Release side repeater lamp from front wing,
disconnect the multiplug and remove the lamp.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст