Range Rover. Manual — part 50
LAND ROVER V8
19
REPAIR
19. Remove bolt securing gearbox fluid cooler pipes
clamp to engine LH mounting bracket and
remove clamp and spacer.
20. Disconnect multiplug from LH KS.
21. Remove bolt securing harness ’P’ clip to cylinder
block.
22. Disconnect multiplug from RH KS.
23. Remove nut securing battery lead to starter
solenoid, release lead and disconnect lucar from
solenoid.
24. Release clip securing harness to engine RH
mounting bracket.
25. Disconnect multiplug from CMP sensor.
26. Disconnect Lucar from oil pressure switch.
27. Release clip securing harness to coolant rail.
28. Remove bolt securing engine earth lead and
position lead aside.
29. Release cover from battery positive terminal.
30. Remove nut securing positive lead to battery
terminal, release fuse box feed lead, and
disconnect positive lead from battery terminal.
31. Release positive lead from battery carrier.
32. Remove 2 screws and remove harness clamp
from battery carrier.
12
ENGINE
NEW RANGE ROVER
20
REPAIR
33. Remove 3 bolts securing under bonnet fuse box.
34. Disconnect engine harness multiplug from fuse
box.
35. Remove nut and disconnect 2 earth leads from
RH wing valance.
36. Disconnect engine harness multiplug from main
harness.
37. Disconnect multiplug from Canister Vent
Solenoid (CVS) unit.
38. Release clip securing harness to RH wing
valance.
39. Release harness clips from fuel rail and heater
coolant pipe.
40. Disconnect multiplug from ECT sensor.
41. Disconnect multiplugs from fuel injectors.
LAND ROVER V8
21
REPAIR
42. Disconnect multiplug from CKP sensor.
43. Remove 2 nuts securing engine harness to
alternator.
44. Remove bolt securing engine harness ’P’ clip to
rear of LH cylinder head.
45. Remove cable tie securing purge pipe to engine
rear lifting eye.
46. Move harness clear of engine.
47. Raise vehicle on ramp.
12
ENGINE
NEW RANGE ROVER
22
REPAIR
48. Remove 6 nuts securing exhaust front pipes to
exhaust manifolds and collect gaskets.
49. Remove 2 nuts securing exhaust front pipe to
intermediate pipe.
50. Release exhaust front pipe from intermediate
pipe.
51. Remove access plug and remove 4 bolts
securing torque converter to drive plate.
52. Using hoist and LRT-12-138 connected to
engine lifting eyes provided, support engine
weight.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст