Range Rover. Manual — part 277
SEATS
35
REPAIR
SEAT OUTSTATION - from 99MY
Service repair no - 78.70.01
NOTE: Seat outstation is used on
electrically operated seats with memory
function.
1. Remove front seat.
See this section.
2. Remove 2 screws securing seat outstation
mounting bracket to cushion frame.
3. Remove 2 nuts securing outstation to mounting
bracket.
4. Release outstation from mounting bracket and
disconnect 4 multiplugs.
5. Remove outstation.
Refit
6. Position outstation, connect multiplugs and
locate on mounting bracket. Fit and tighten nuts.
7. Align outstation mounting bracket to cushion
frame and fit screws.
8. Fit seat.
See this section.
MOTOR - TILT - FRONT SEAT - from 99MY
Service repair no - 78.70.29
Remove
1. Remove front seat.
See this section.
2. Disconnect and release multiplug from bracket.
3. Remove roll pin securing motor.
4. Remove spring clip securing operating rod to
lever.
5. Release and remove motor assembly.
78
SEATS
NEW RANGE ROVER
36
REPAIR
Refit
6. Clean lever pivot and smear with grease.
7. Position motor assembly and locate operating
rod to lever. Fit new spring clip.
8. Align motor and fit new roll pin.
9. Connect multiplug and secure to bracket.
10. Fit seat.
See this section.
LATCH REAR SEAT
Service repair no - 78.80.12
Remove
1. Fold adjacent seat forward.
2. Remove 3 screws securing latch cover. Remove
cover.
3. Slacken seat belt stalk bolt.
4. Remove 4 screws securing latch to seat
assembly. Remove latch.
NOTE: Fold top of latch forward to release.
5. Remove bolt securing seat belt stalk. Remove
stalk.
SEATS
37
REPAIR
Refit
6. Hold latch in vice. Position seat belt stalk.
Secure with bolt. Tighten to
35 Nm. (26 lbf.ft)
7. Position latch. Align to cushion and squab.
8. Secure with screws. Tighten to
30 Nm.
(22 lbf.ft)
9. Fit latch cover. Secure with screws.
10. Return seat to original position.
SWITCH - FRONT SEAT CONTROL
Service repair no - 78.70.89
Remove
1. Remove 2 screw plugs from seat valance.
2. Remove 2 screws securing valance.
3. Release stud securing harness to seat frame.
4. Disconnect harness from seat ECU.
5. Remove valance/switch assembly.
Refit
6. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст