Range Rover. Manual — part 275
SEATS
27
REPAIR
MOTOR - RECLINE - FRONT SEAT - up to 99MY
Service repair no - 78.70.35
Remove
1. Remove front seat.
See this section.
2. Remove 2 plugs from seat inner valance
retaining screws. Remove 2 screws. Remove
valance.
3. Remove 2 clips securing squab cover retainer to
cushion frame. Release retainer.
4. Disconnect headrest/recline multiplug from
connection under cushion.
5. Remove 4 bolts securing squab to seat. Remove
squab.
6. Remove 2 squab cover clips. Release squab
retainer from squab frame.
78
SEATS
NEW RANGE ROVER
28
REPAIR
7. Release cover retention wires from frame. Roll
cover back for access.
8. Disconnect recline motor multiplug from seat
harness.
9. Remove 2 bolts securing motor to frame.
Remove motor.
Refit
10. Reverse removal procedure.
MOTOR - RECLINE - FRONT SEAT - from 99MY
Service repair no - 78.70.35
Remove
1. Remove front seat.
See this section.
2. Remove armrest retaining screw cover.
3. Remove screw securing armrest, collect
anti-rattle washer.
4. Remove armrest and escutcheon.
5. Remove 2 clips and release retainer securing
rear section of cover to frame.
6. Remove 2 clips and release retainer securing
front section of cover to frame.
SEATS
29
REPAIR
7. Remove cable ties securing harnesses to
cushion spring. Release heating element
harness and SRS harness 2 way connector.
8. Disconnect multiplug from control unit.
9. Release harness from squab cover.
10. Remove bolt securing seat belt stalk.
11. Remove seat belt stalk.
12. Remove 2 screw covers.
13. Remove 3 screws securing inner side finisher.
14. Remove side finisher.
15. Remove 2 screw covers.
16. Remove 2 screws securing outer side finisher.
Release side finisher and move aside for
access.
17. Raise squab cover for access.
78
SEATS
NEW RANGE ROVER
30
REPAIR
18. Disconnect 2 multiplugs from motor.
19. Remove clip securing drive shaft and withdraw
drive shaft from motor.
20. Remove Torx screw securing motor.
21. Remove motor and collect 2 rubber washers.
Refit
22. Fit rubber washers, position motor and fit Torx
screw.
23. Locate drive shaft and fit clip.
24. Connect multiplug.
25. Lower squab cover.
26. Pass harness through cover and connect
multiplug.
27. Align seat heating element harness and secure
harnesses with cable ties.
28. Secure SRS connector to bracket.
29. Secure front section cover retainer to frame and
fit clips.
30. Secure rear section cover retainer to frame and
fit clips.
31. Fit armrest escutcheon.
32. Fit armrest and position anti-rattle washer. Fit
and tighten bolt.
33. Position outer side finisher and fit screws and
covers.
34. Fit inner side finisher, fit screws and screw
covers.
35. Position seat belt stalk, fit bolt and tighten to
35 Nm (26 lbf.ft).
36. Fit seat.
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст