Range Rover. Manual — part 276
SEATS
31
REPAIR
SEAT POWER RELAY
Service repair no - 78.70.47
NOTE: 2 power relays are fitted to
electrically operated seats without
position memory function.
Remove
1. If possible, raise seat cushion to full extent to
improve access to relays.
2. Remove relay from connector block.
Refit
3. Reverse removal procedure.
MOTOR - RISE AND FALL - FRONT SEAT - up to
99MY
Service repair no - 78.70.27
Remove
1. Remove front seat.
See this section.
2. Note fitted position of wires. Disconnect 2 Lucars
from motor.
3. Remove 2 screws securing motor to mounting
bracket. Remove motor.
Refit
4. Reverse removal procedure.
78
SEATS
NEW RANGE ROVER
32
REPAIR
MOTOR - RISE AND FALL - FRONT SEAT - from
99MY
Service repair no - 78.70.27
Remove
1. Remove front seat.
See this section.
2. Disconnect and release multiplug from bracket.
3. Remove roll pin securing motor.
4. Remove spring clip securing operating rod to
lever.
5. Release and remove motor assembly.
Refit
6. Clean lever pivot and smear with grease.
7. Position motor assembly and locate operating
rod to lever. Fit new spring clip.
8. Align motor and fit new roll pin.
9. Connect multiplug and secure to bracket.
10. Fit seat.
See this section.
SEATS
33
REPAIR
REAR SEATS
Service repair no - 78.10.47/99
Remove
1. Remove screws securing seat bolt covers.
Remove covers.
2. Remove 2 front retaining bolts.
3. Release seat and fold forward.
4. Remove 2 rear retaining bolts.
5. Remove seat.
Refit
6. Position seat.
7. Fit front bolts. Do not tighten.
8. Fit rear bolts. Tighten to
29 Nm. (22 lbf.ft)
9. Tighten front bolts. Tighten to
29 Nm. (22 lbf.ft)
10. Fit bolt covers. Secure with screws.
78
SEATS
NEW RANGE ROVER
34
REPAIR
SEAT OUTSTATION - up to 99MY
Service repair no - 78.70.01
NOTE: Seat outstation is used on
electrically operated seats with position
memory function.
Remove
1. Remove seat.
See this section.
2. Remove 2 bolts securing front of seat frame to
cushion pan.
3. Slacken 2 bolts securing rear of seat frame.
4. Disconnect 4 multiplugs.
5. Remove 2 nuts securing outstation to frame.
6. Lift front of seat frame away from cushion pad to
provide clearance for outstation removal.
Remove outstation.
Refit
7. Reverse removal procedure.
8. Tighten bolts securing cushion pan to frame to
29 Nm. (21 lbf.ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст