Range Rover. Manual — part 327
ELECTRICAL
49
REPAIR
7. Disconnect multiplug from purge valve.
8. Remove bolt securing engine oil cooler return
pipe to alternator mounting bracket.
9. Loosen engine oil cooler return pipe union from
oil pump.
10. Release return pipe, remove and discard ’O’
ring.
CAUTION: Plug the connections.
11. Disconnect multiplug from LH KS.
12. Remove bolt securing harness ’P’ clip to cylinder
block.
13. Disconnect multiplug from RH KS.
14. Remove nut securing battery lead to starter
solenoid, release lead and disconnect Lucar
from solenoid.
15. Release clip securing harness to engine RH
mounting bracket.
86
ELECTRICAL
NEW RANGE ROVER
50
REPAIR
16. Disconnect multiplug from CMP sensor.
17. Disconnect Lucar from oil pressure switch.
18. Release clip securing harness to coolant rail.
19. Remove bolt securing engine earth lead and
position lead aside.
20. Release cover from battery positive terminal.
21. Remove nut securing positive lead to battery
terminal, release fuse box feed lead, and
disconnect positive lead from battery terminal.
22. Release positive lead from battery carrier.
23. Remove 2 screws and remove harness clamp
from battery carrier.
24. Remove 3 bolts securing under bonnet fuse box.
25. Disconnect engine harness multiplug from fuse
box.
26. Remove nut and disconnect 2 earth leads from
RH wing valance.
ELECTRICAL
51
REPAIR
27. Disconnect engine harness multiplug from main
harness.
28. Disconnect multiplug from purge control vent
valve.
29. Release clip securing harness to RH wing
valance.
30. Release harness clips from fuel rail and heater
coolant pipe.
31. Disconnect multiplug from ECT sensor.
32. Disconnect multiplugs from fuel injectors.
33. Disconnect multiplug from CKP sensor.
34. Remove 2 nuts securing engine harness to
alternator.
86
ELECTRICAL
NEW RANGE ROVER
52
REPAIR
35. Remove bolt securing engine harness ’P’ clip to
rear of LH cylinder head.
36. Remove cable tie securing purge pipe to engine
rear lifting eye.
37. Models with automatic gearbox: Remove
window switch pack.
See this section.
38. Models with manual gearbox: Remove centre
console.
See CHASSIS AND BODY, Repair.
39. Models with manual gearbox: Remove 6 nuts
securing gear lever gaiter ring and remove gaiter
ring and gaiter.
40. Models with manual gearbox: Remove 2 bolts
securing gear lever and remove lever.
41. With handbrake released, remove clip and clevis
pin securing handbrake cable to handbrake.
42. Remove chassis crossmember.
See CHASSIS
AND BODY, Repair.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст