Range Rover. Manual — part 318
ELECTRICAL
13
REPAIR
6. Lift 2 clips securing each switch pack. Remove
switch packs and printed circuit assembly.
Refit
7. Reverse removal procedure.
ELECTRIC WINDOW SWITCH PACK
Service repair no - 86.25.08
Remove
1. Remove 2 screws securing switch pack to centre
console.
2. Release switch pack. Disconnect multiplug.
3. Withdraw gaiter over handbrake. Remove switch
pack.
Refit
4. Reverse removal procedure.
86
ELECTRICAL
NEW RANGE ROVER
14
REPAIR
ULTRASONIC SENSOR
Service repair no - 86.55.96
Remove
1. Release ultrasonic sensor from headlining.
2. Disconnect multiplug. Remove sensor.
Refit
3. Reverse removal procedure.
RECEIVER
Service repair no - 86.55.38
Remove
1. Remove RH parcel shelf support trim.
See
CHASSIS AND BODY, Repair.
2. Disconnect Lucar and multiplug from receiver.
3. Remove screw. Remove receiver.
Refit
4. Reverse removal procedure.
ELECTRICAL
15
REPAIR
SWITCH TAILGATE RELEASE
Service repair no - 86.26.26
Remove
1. Release 3 studs securing tailgate board.
Remove board.
2. Disconnect tailgate switch multiplug.
3. Remove 2 screws securing switch to tailgate.
4. Turn switch clockwise to remove.
Refit
5. Reverse removal procedure.
TAILGATE SOLENOID
Service repair no - 86.26.02
Remove
1. Release studs securing tailgate board. Remove
board.
2. Release solenoid operating rod from tailgate
latch.
3. Remove 3 screws securing solenoid assembly.
4. Disconnect multiplug. Remove solenoid.
86
ELECTRICAL
NEW RANGE ROVER
16
REPAIR
5. Remove 2 screws securing solenoid to mounting
plate. Remove solenoid.
6. Release clip. Remove operating rod from
solenoid.
Refit
7. Reverse removal procedure.
BODY ELECTRICAL CONTROL MODULE (BeCM)
Service repair no - 86.55.98
Remove
1. Disconnect battery negative lead.
2. Remove RH front seat for access.
See SEATS,
Repair.
3. Remove 2 screws securing heater rear outlet
duct. Remove duct.
4. Release carpet over BeCM. Position aside.
5. Remove 2 nuts and screw securing BeCM to
mounting.
6. Disconnect multiplugs from BeCM.
7. Release terminal covers.
8. Disconnect 1 earth and 3 feed wires.
9. Remove BeCM.
Refit
10. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст