Range Rover. Manual — part 273
SEATS
19
REPAIR
5. Remove 2 clips securing squab cover retainer to
cushion frame. Release retainer.
6. Disconnect headrest and recline multiplug from
connection under cushion.
7. Remove 4 bolts securing squab to seat. Remove
squab.
8. Remove cover from armrest screw. Remove
screw and armrest.
9. Remove 2 clips securing squab cover retainer to
squab frame. Release retainer.
78
SEATS
NEW RANGE ROVER
20
REPAIR
10. Release cover retention wires from frame. Roll
cover back for access.
11. Remove 4 Hog rings from front and 4 Hog rings
from rear of squab cover.
12. Roll cover back further. Remove 4 Hog rings
securing front of cover.
13. Disconnect remaining ends of retention wires.
14. Remove cover from frame.
15. Remove foam.
NOTE: Heating element is integral with
foam.
SEATS
21
REPAIR
Refit
16. Reverse removal procedure.
LATCH REAR SQUAB
Service repair no - 78.80.16.
Remove
1. Lower rear seat squab.
2. Remove parcel tray and trim support panels.
See CHASSIS AND BODY, Repair.
3. Disconnect squab release rod from latch.
4. Remove 2 screws securing latch. Remove latch.
Refit
5. Reverse removal procedure.
6. Tighten latch securing screws to
14 Nm. (10
lbf.ft)
78
SEATS
NEW RANGE ROVER
22
REPAIR
MOTOR FORWARD/REARWARD
Service repair no - 78.70.25
Remove
1. Remove front seat.
See this section.
2. Remove 2 plugs from seat inner valance
retaining screws. Remove 2 screws.
3. Remove inner valance.
4. Disconnect multiplug from forward/rear motor.
5. Release multiplug from bracket. Remove strap
securing motor harness to motor mounting
bracket.
6. Remove 2 screws securing motor mounting
bracket to gearbox bracket.
7. Remove bolt and shouldered spacer securing
gearbox to mounting bracket.
8. Remove rear nut securing forward/rear slide
bracket to cross tubes.
9. Slacken front nut securing forward/rear slide
bracket to cross tubes.
10. Remove spring clip securing drive cable cover to
gearbox.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст