Range Rover. Manual — part 274
SEATS
23
REPAIR
11. Remove 4 screws securing motor to mounting
bracket.
12. Release forward/rear slide bracket from rear
cross tube.
13. Raise slide bracket. Disconnect drive cable from
gearbox.
14. Remove drive cable from motor. Remove motor
from mounting bracket.
15. Remove second drive cable from gearbox.
Refit
16. Reverse removal procedure.
MOTOR - HEADREST - FRONT SEAT - up to 99MY
Service repair no - 78.70.31
Remove
1. Remove front seat.
See this section.
2. Remove 2 plugs from seat inner valance
retaining screws. Remove 2 screws. Remove
valance.
3. Remove 2 clips securing squab cover retainer to
cushion frame. Release retainer.
78
SEATS
NEW RANGE ROVER
24
REPAIR
4. Disconnect headrest and recline multiplug from
connection under cushion.
5. Remove 4 bolts securing squab to seat. Remove
squab.
6. Remove 2 squab cover clips. Release squab
retainer from squab frame.
7. Release cover retention wires from frame. Roll
cover back for access
8. Remove 2 bolts securing motor to frame.
Release motor.
9. Note fitted position of wires. Disconnect 2 Lucars
from motor.
10. Remove cable retaining clip. Remove motor from
cable.
Refit
11. Reverse removal procedure.
SEATS
25
REPAIR
MOTOR - HEADREST - FRONT SEAT - from 99MY
Service repair no - 78.70.31
Remove
1. Remove front seat.
See this section.
2. Remove armrest retaining screw cover.
3. Remove screw securing armrest, collect
anti-rattle washer.
4. Remove armrest and escutcheon.
5. Remove 2 clips and release retainer securing
rear section of cover to frame.
6. Remove 2 clips and release retainer securing
front section of cover to frame.
7. Remove cable ties securing harnesses to
cushion spring. Release heating element
harness and SRS harness 2 way connector.
8. Disconnect multiplug from control unit.
9. Release harness from squab cover.
10. Raise squab cover for access.
78
SEATS
NEW RANGE ROVER
26
REPAIR
11. Disconnect motor multiplug.
12. Remove 2 Torx screws securing motor.
13. Release motor and noting fitted positions,
disconnect 2 Lucars from motor.
14. Remove drive cable retaining clip.
15. Remove motor.
Refit
16. Fit motor, locate drive cable and secure with clip.
17. Connect Lucars, align motor to frame and fit
Torx screws.
18. Lower squab cover.
19. Pass harness through squab cover and connect
multiplug.
20. Align seat heating element harness and secure
harnesses with cable ties.
21. Secure SRS connector to bracket.
22. Secure front section cover retainer to frame and
fit clips.
23. Secure rear section cover retainer to frame and
fit clips.
24. Fit armrest escutcheon.
25. Fit armrest and position anti-rattle washer. Fit
and tighten bolt.
26. Fit seat.
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст