Range Rover. Manual — part 187
ELECTRONIC AIR SUSPENSION
9
REPAIR
BUMP STOP
Service repair no - 60.30.10
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Pull bump stop from body.
Refit
3. Fit bump stop.
4. Remove safety stands. Lower vehicle.
COMPRESSOR INLET FILTER
Service repair no - 60.50.12
Remove
CAUTION: Dirt or grease must not enter
the system.
1. Remove cover from air supply unit.
2. Remove inlet filter from compressor.
Refit
3. Apply Loctite 572 to filter threads.
4. Fit filter Tighten to
1.0 Nm. (0.74 lbf.ft). Refit
cover.
60
FRONT SUSPENSION
NEW RANGE ROVER
10
REPAIR
DELAY TIMER UNIT
Service repair no - 60.50.46
Remove
1. Raise LH front seat cushion to full extent to
improve access to timer unit.
2. Remove timer unit from terminal block.
Refit
3. Reverse removal procedure.
AIR DRIER
Service repair no - 60.50.09
Remove
WARNING: The air suspension is
pressurised up to 10 bar (150 psi). Dirt or
grease must not enter the system. Wear
hand, ear and eye safety standard protection
when servicing the system.
1. Disconnect 2 pipes from air drier.
2. Seal pipes. Seal drier to prevent moisture
ingress.
3. Remove air drier fixing, remove drier.
Refit
4. Fit drier, tighten fixing to
12 Nm (9 lbf.ft).
5. Remove seals, clean end of pipes.
6. Connect hoses to drier.
7. Leak test connections.
See this section.
ELECTRONIC AIR SUSPENSION
11
REPAIR
ELECTRONIC CONTROL UNIT (ECU)
Service repair no - 60.50.04
Remove
1. Move front left hand seat fully rearwards.
2. Disconnect battery negative lead.
3. Remove 3 trim fixings, remove trim from seat
base.
4. Remove 2 screws from ECU cover (automatic
only), remove cover.
5. Release multiplug from ECU.
6. Remove 2 screws, remove ECU.
Refit
7. Reverse removal procedure.
60
FRONT SUSPENSION
NEW RANGE ROVER
12
REPAIR
HEIGHT SENSOR
Service repair no - 60.36.01
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove scrivet from rear lower edge of front
wheel arch liner. Lift liner for access to height
sensor multiplug.
3. Disconnect multiplug.
4. Release sensor link from radius arm.
5. Remove 2 bolts and remove sensor and sensor
cover.
6. Remove cover from sensor.
Refit
7. Fit cover to sensor.
8. Fit sensor, tighten bolts to
12 Nm. (9 lbf.ft)
CAUTION: Ensure bolts pass through
cover and sensor.
9. Fit sensor link to radius arm. Tighten to
8 Nm.
(6 lbf.ft)
10. Reverse removal procedure.
11. Recalibrate system if a new sensor has been
fitted
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст