Frelander 2. Manual — part 319
Electronic Engine Controls - TD4 2.2L Diesel - Exhaust Gas Temperature
Sensor
Removal and Installation
Removal
WARNING: Observe due care when working near a hot exhaust system.
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the engine cover.
Refer to: Engine Cover - 2.2L Diesel (501-05, Removal and
Installation).
2.
3.
4.
CAUTION: Before disconnecting or removing the
components, make sure the area around the joint faces
and connections are clean. Plug open connections to
prevent contamination.
Torque: 35 Nm
4.
Installation
Apply anti-seize compound to the sensor threads.
Refer to: Specifications (303-08, Specifications).
1.
To install, reverse the removal procedure.
2.
Electronic Engine Controls - TD4 2.2L Diesel - Diesel Particulate Filter (DPF)
Temperature Sensor
Removal and Installation
Removal
WARNING: Observe due care when working near a hot exhaust system.
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
2.
3.
CAUTION: Before disconnecting or removing the
components, make sure the area around the joint faces
and connections are clean. Plug open connections to
prevent contamination.
Torque: 35 Nm
3.
Installation
Apply anti-seize compound to the sensor threads.
Refer to: Specifications (303-08, Specifications).
1.
To install, reverse the removal procedure.
2.
Automatic Transmission/Transaxle -
Lubricants, Fluids, Sealers and Adhesives
• CAUTIONS:
* Do not use any lubricant other than that specified
+ Do not over lubricate
Item
Specification
Recommended lubricant - 3.2 Petrol *
Esso JWS 3309 US. Land Rover Part No LR002748
Recommended lubricant - 2.2 Diesel, Vehicles built up to 2011 *
Esso JWS 3309 US. Land Rover Part No LR002748
Recommended lubricant - 2.2 Diesel, Vehicles built from 2011 *
Nippon AW-1. Land Rover Part No LR0022460
Torque converter nose+
Molykote FB180
Driveshaft spline grease
Weicon Anti Seize - 6G92M1C27AA
Fluid pan to transmission sealant
LR002912
Capacities
CAUTION: * A final oil level/check/top-up must be carried out when the unit has been installed
Item
Capacity (liters/pints/US quarts)
Initial dry fill*
7.0/12.3/7.4
General Specification
Item
Specification
Automatic transmission
Aisin AW F21 (6 speed auto)
Torque - Maximum:
3.2 Petrol
315 Nm (232 lb-ft)
2.2 Diesel
450 Nm (332 lb-ft)
Gear ratios:
First
4.148:1
Second
2.370:1
Third
1.556:1
Fourth
1.155:1
Fifth
0.859:1
Sixth
0.686:1
Reverse
3.394:1
Final drive ratio:
3.2 Petrol
3.750:1
2.2 Diesel
3.329:1
Torque converter:
3.2 Petrol
D260 170K
2.2 Diesel
D260 186K2
Transmission control module:
Location
Integrated onto top transmission casing
Type - 3.2 Petrol, Vehicles built from 2007 to 2009
SH 7055
Type - 2.2 Diesel, Vehicles built from 2007 to 2010
SH 7055
Type - 3.2 Petrol, Vehilces built up to 2011
SH 7058
Type - 3.2 Petrol and 2.2 Diesel, Vehicles built from 2011
SH 7058
Torque Specifications
Description
Nm
lb-ft
3 way solenoid S1
10
7
3 way solenoid S2
10
7
Cover plate bolt - PTU side - 2.2 Diesel only
24
18
Cover plate bolt- starter side - 2.2 Diesel only
24
18
Drain plug bolt
47
35
Fill plug Torx bolt
39
29
Flexplate to torque converter bolts
60
44
Fluid pan Torx bolts
13
10
Lock plate bolt - oil temperature sensor
10
7
Main control valve body bolts
10
7
Overflow Torx bolt
7
5
Suction cover - valve body assy
10
7
Transmission control module (TCM) bolts
24
18
Transmission control module (TCM) support bracket
25
18
Speed Sensor - Input
5
3.7
Transmission to engine bolts - M10:
3.2 Petrol
48
35
2.2 Diesel
65
48
Transmission to engine bolts - M8 - petrol 3.2l engine only
24
18
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст