Frelander 2. Manual — part 317
Electronic Engine Controls - TD4 2.2L Diesel - Crankshaft Position (CKP)
Sensor Ring
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the crankshaft pulley.
Refer to:
Crankshaft Pulley
(303-01B Engine - TD4 2.2L Diesel,
Removal and Installation).
2.
3.
CAUTION: "Make sure that a new component is
installed. "
• NOTE: M6 bolts can be used to extract the
component.
• NOTE: Make sure that this component is installed to
the noted removal position.
3.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - TD4 2.2L Diesel - Engine Control Module (ECM)
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the plenum chamber panel.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
2.
3.
Petrol ECM shown, diesel similar.
4.
Torque: 6 Nm
5.
Installation
All vehicles
To install, reverse the removal procedure.
1.
Vehicles with diesel particulate filter (DPF)
Renew the engine oil and filter.
Refer to:
Engine Oil Draining and Filling
(303-01B Engine - TD4 2.2L
Diesel, General Procedures).
2.
All vehicles
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
3.
Electronic Engine Controls - TD4 2.2L Diesel - Fuel Temperature Sensor
Removal and Installation
Removal
• W ARNINGS:
Avoid flames, sparks or lighted substances.
W ait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection
system.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Torque: 10 Nm
3.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст