Frelander 2. Manual — part 527
Attach the liftgate wiring harness.
3.
Connect the liftgate wiring harness electrical connectors.
4.
W ith the liftgate closed, check the alignment of the liftgate to the
roof panel and bodyside panel. The liftgate should be central in its
aperture.
5.
Loosen, but do not remove the liftgate hinge bolts.
6.
Position the liftgate central to the aperture.
7.
Tighten the liftgate hinge bolts.
Torque: 24 Nm
8.
Attach the rear of the headliner.
9.
Install the LH D-pillar upper trim panel.
Refer to:
D-Pillar Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
10.
Check for correct operation of the liftgate, and if necessary adjust
the liftgate striker.
11.
Body Closures - Rear Door
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Torque: 24 Nm
2.
3.
CAUTION: Protect the surrounding trim to avoid
damage.
• NOTE: This step requires the aid of another
technician.
Torque: 30 Nm
3.
4.
Installation
To install, reverse the removal procedure.
1.
Interior Trim and Ornamentation -
Torque Specifications
Description
Nm
lb-ft
A-pillar trim panel Torx screw
3
2
A-pillar airbag deflector bracket bolts
9
7
B-pillar trim panel upper Torx bolt
25
18
C-pillar upper trim panel Torx screw
3
2
Engine cover 2.2 Diesel
10
7
Liftgate trim panel
1
1
Loadspace securing ring
25
18
Passenger assist handles
2
1
Sunvisors
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст