Frelander 2. Manual — part 316
Electronic Engine Controls - TD4 2.2L Diesel - Engine Oil Pressure (EOP)
Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Raise and support the vehicle.
2.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
3.
4.
5.
6. CAUTIONS:
Be prepared to collect escaping fluids.
Replace the washer.
Torque: 32 Nm
6.
Installation
To install, reverse the removal procedure.
1.
Check and top-up the engine oil if required.
2.
Electronic Engine Controls - TD4 2.2L Diesel - Intake Manifold Runner
Control (IMRC) Actuator
Removal and Installation
Removal
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
1.
Torque: 10 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - TD4 2.2L Diesel - Mass Air Flow (MAF) Sensor
Removal and Installation
Removal
Torque: 2 Nm
1.
Installation
To install, reverse the removal procedure.
1.
2. NOTE: For NAS vehicles only.
If required, carry out a short drive cycle.
Refer to: Powertrain Control Module (PCM) Short Drive Cycle
Self-Test (303-14A, General Procedures).
2.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст