Frelander 2. Manual — part 288
Engine Emission Control - TD4 2.2L Diesel - Valve Cover Vent Oil Separator
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
2.
Remove the fuel rail.
Refer to:
Fuel Rail
(303-04B Fuel Charging and Controls - TD4 2.2L
Diesel, Removal and Installation).
3.
4.
5.
Torque: 6 Nm
6.
7.
Torque: 8 Nm
8.
9.
Remove and discard the hose clips.
10.
11.
CAUTION: Incorrect installation of the
camshaft position (CMP) sensor could result in engine
damage.
Insert a 7.5 mm diameter drill between the
valve cover and the CMP sensor as shown, to
achieve the correct alignment of the CMP
sensor.
Torque: 4 Nm
11.
Remove and discard the hose clip.
12.
13.
CAUTION: Tighten the bolts in the sequence
shown.
• NOTE: Remove and discard the O-ring seals.
Torque: 9 Nm
13.
Installation
1.
CAUTION: Make sure that the mating faces are clean and
free of corrosion and foreign material.
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст