Frelander 2. Manual — part 79
Driveshaft - DriveshaftVehicles With: Diesel Particulate Filter (DPF)
Removal and Installation
Removal
• NOTE: If a new drive shaft is to be installed, remove the seal protector from the front sliding joint.
• NOTE: Removal steps in this procedure may contain installation details.
• NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1.
WARNING: Make sure to support the vehicle with axle
stands.
• NOTE: All vehicles.
Raise and support the vehicle.
1.
Remove the Diesel Particulate Filter (DPF).
Refer to:
Diesel Particulate Filter (DPF)
(309-00B Exhaust System -
TD4 2.2L Diesel, Removal and Installation).
2.
3.
4.
WARNING: Do not lever the driveshaft joints to
release from the power transfer unit or the rear
differential flanges.
• CAUTIONS:
Make sure that the driveshaft is supported with
suitable retaining straps.
Make sure that new bolts are installed.
Torque: 40 Nm
4.
5.
W ARNING: Do not lever the driveshaft joints
to release from the power transfer unit or the rear
differential flanges.
• CAUTIONS:
Make sure that the driveshaft is supported with
suitable retaining straps.
Make sure that new bolts are installed.
Torque: 40 Nm
5.
6. NOTE: All vehicles built up to VIN 180237, and all
TD4 Automatics built from VIN 180238
Torque: 25 Nm
6.
7. NOTE: All vehicles.
• NOTE: This step requires the aid of another
technician.
Torque: 25 Nm
7.
8. NOTE: Do not disassemble further if the component
is removed for access only.
• NOTE: All vehicles built up to VIN 180237, and all
TD4 Automatics built from VIN 180238
Torque: 25 Nm
8.
9. NOTE: TD4 Manual built from VIN 180238
Torque: 25 Nm
9.
Installation
To install, reverse the removal procedure.
1.
Rear Drive Axle/Differential -
Lubrication
Description
Lubricant
Capacity (liters/pints/US quarts)
Haldex controlled coupling Statoil SL01-301. Land Rover Part No LR003136
0.65/1.1/0.69
Rear drive axle/differential Castrol Axle EPX 80W-90. Land Rover Part No LR003156
0.7/1.2/0.74
General Specification
Item
Specification
Differential type
Low offset hypoid spiral bevel design
Ratio
2.58:1
Electronic torque managed (ETM) range
Up to 1500 Nm (1106 lbf.ft)
Torque Specifications
Description
Nm
lb-ft
Active on-demand coupling module
6
4
Active on-demand coupling to differential
24
18
Active on-demand oil pump
6
4
Driveshaft to the rear flange*
40
30
Rear differential front bush retaining bolts*
175
129
Rear differential insulator to the rear differential
25
18
Rear differential rear bush retaining bolts*
110
81
Rear differential support bracket
25
18
Rear drive axle/differential pinion flange nut*
130
96
Rear drive axle/differential fluid drain plug
35
26
Rear drive axle/differential fluid filler plug
35
26
* New nuts/bolts must be fitted
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст