Frelander 2. Manual — part 78
Driveshaft - Driveshaft
Diagnosis and Testing
For additional information.
REFER to:
Driveline System
(205-00 Driveline System - General Information, Diagnosis and Testing).
Driveshaft - DriveshaftVehicles Without: Diesel Particulate Filter (DPF)
Removal and Installation
Removal
• NOTE: If a new drive shaft is to be installed, remove the seal protector from the front sliding joint.
• NOTE: Removal steps in this procedure may contain installation details.
• NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1.
WARNING: Make sure to support the vehicle with axle
stands.
• NOTE: All vehicles.
Raise and support the vehicle.
1.
Remove the exhaust system.
Refer to:
Exhaust System
(309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
2.
3.
4.
WARNING: Do not lever the driveshaft joints to
release from the power transfer unit or the rear
differential flanges.
• CAUTIONS:
Make sure that the driveshaft is supported with
suitable retaining straps.
Make sure that new bolts are installed.
Torque: 40 Nm
4.
5.
W ARNING: Do not lever the driveshaft joints
to release from the power transfer unit or the rear
differential flanges.
• CAUTIONS:
Make sure that the driveshaft is supported with
suitable retaining straps.
Make sure that new bolts are installed.
Torque: 40 Nm
5.
6. NOTE: All vehicles built up to VIN 180237, and all
TD4 Automatics built from VIN 180238
Torque: 25 Nm
6.
7. NOTE: All vehicles.
• NOTE: This step requires the aid of another
technician.
Torque: 25 Nm
7.
8. NOTE: Do not disassemble further if the component
is removed for access only.
• NOTE: All vehicles built up to VIN 180237, and all
TD4 Automatics built from VIN 180238
Torque: 25 Nm
8.
9. NOTE: TD4 Manual, and all Si6 built from VIN 180238
Torque: 25 Nm
9.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст