Frelander 2. Manual — part 388
Fuel System - General Information - Fuel System BleedingTD4 2.2L Diesel
General Procedures
Special Tool(s)
310-163
Bleeder, Fuel System
• W ARNINGS:
Avoid flames, sparks or lighted substances.
W ait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection
system.
CAUTION: Make sure that the area around the component is clean and free of foreign material.
This procedure is necessary if any of the following fuel system
components are removed, disconnected or replaced: Fuel tank, low
pressure fuel lines or the fuel filter.
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
3. CAUTIONS:
Extreme cleanliness must be exercised when
handling these components.
Be prepared to collect escaping fuel.
Disconnect the fuel line.
3.
4.
CAUTION: Be prepared to collect escaping fuel.
• NOTE: Make sure that the fuel flow direction arrow on
the special tool is pointing towards the fuel filter.
Install the special tool between the fuel supply
line and the fuel filter.
Special Tool(s):
310-163
Prime the fuel filter by squeezing the hand
pump several times until the pump is hard.
4.
Remove the special tools.
5.
Special Tool(s):
310-163
Connect the fuel lines.
Install the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
6.
Fuel Tank and Lines - I6 3.2L Petrol -
Capacities
Item
Capacity (liters/gallons)
Fuel tank
70.0/15.4
General Specification
Item
Specification
System type
ERFS Electronic Returnless Fuel System
Fuel delivery module
PAG Module
Fuel pump:
Maximum output @ 11.5 volts min
110l/hr max
Operating pressure
Variable
Maximum operating pressure
3.8 Bar max
Fuel tank sender units
Magnetic Passive Position Sensor (MAPPS)
Torque Specifications
Description
Nm
lb-ft
Fuel tank bolts*
25
18
Fuel tank filler pipe lower bracket
10
7
Fuel tank filler pipe upper bracket
10
7
* New nuts/bolts must be fitted
Fuel Tank and Lines - I6 3.2L Petrol - Fuel Tank and Lines
Description and Operation
COMPONENT LOCATION
Item
Part Number
Description
1
-
Filler neck
2
-
Fuel tank
3
-
Evaporative emission canister - Rest of World (ROW) derivative
4
-
Evaporative emission canister - North American Specification (NAS) derivative
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст