Frelander 2. Manual — part 523
Front End Body Panels - Secondary Bulkhead Center PanelTD4 2.2L Diesel
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Remove the plenum chamber.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
3.
4.
5.
Release the secondary bulkhead center panel pad.
6.
Torque: 10 Nm
7.
8.
Installation
To install, reverse the removal procedure.
1.
Front End Body Panels - Hood Latch Panel
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the headlamps.
Refer to:
Headlamp Assembly
(417-01 Exterior Lighting, Removal
and Installation).
2.
3. NOTE: Do not disassemble further if the component is removed
for access only.
Remove the front impact sensors.
Refer to:
Front Impact Severity Sensor
(501-20B Supplemental
Restraint System, Removal and Installation).
3.
Remove the front fenders.
Refer to:
Fender
(501-02 Front End Body Panels, Removal and
Installation).
4.
Release and tie aside the power steering reservoir.
5.
Release the windshield washer reservoir filler neck.
6.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст