Frelander 2. Manual — part 178
Install the accessory drive belt idler pulley.
Torque: 25 Nm
11.
Install the accessory drive pulley.
Refer to:
Accessory Drive Pulley
(303-05A Accessory Drive - I6 3.2L
Petrol, Removal and Installation).
12.
Fill and bleed the cooling system.
Refer to:
Cooling System Draining, Filling and Bleeding
(303-03A
Engine Cooling - I6 3.2L Petrol, General Procedures).
13.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
14.
Engine - I6 3.2L Petrol - Timing Components Housing
Removal and Installation
Special Tool(s)
303-1232
Guide Pins
Removal
• NOTE: Take extra care when aligning and refitting the timing housing , as the seals can easily be damaged .
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
2.
Remove the timing chain and sprockets.
Refer to:
Timing Chain
(303-01A Engine - I6 3.2L Petrol, Removal
and Installation).
3.
Disconnect the front LH HO2S and release the clip.
4.
Remove the power steering pump support bracket
5.
Release the power steering pump.
6.
7.
CAUTION: Discard the seal.
7.
Release the power steering gear line.
8.
Release the coolant rail.
9.
10.
CAUTION: The O-ring seal is to be reused
unless damaged.
Disconnect the coolant rail hose from the coolant pump
housing.
10.
11.
12.
CAUTION: Discard the seal.
• NOTE: Discard the gasket.
12.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст